CAP 3W3101 - Caterpillar

1. Lift latch (1) to slide the windows. Squeeze latch (2) to release window from the CLOSED position.2. Move handle stop (3) to the UP position by lifting the handle and rotating counterclockwise until it is vertical.3. Move the section of the window that slides to opening (4) in the upper window channel.4. Tilt the top of the window toward the inside of the cab and remove it.Seat Belt
Inspect for Wear or Damage
Seat belt and mounting hardware must be inspected for wear or damage before operating the machine. Replace the belt or mounting hardware if worn or damaged.Replace the seat belt after three years of usage, regardless of appearance.Engine Crankcase
Check Oil Level
Do not overfill the crankcase. Engine damage can result.
1. Open the access cover on the left side of the machine. 2. Maintain the oil level between the ADD and FULL marks on the engine running side of dipstick (1) with the engine running.Maintain the oil level between the LOW and FULL marks on the engine stopped side of dipstick (1) with the engine stopped. When operating on severe slopes, the oil level in the engine crankcase must be at the FULL mark on the engine stopped side of the dipstick. 3. Remove oil fill plug (2) and add oil if necessary.4. Clean and install the fill plug.5. Close the access cover.Transmission System
Check Oil Level
1. Open the access cover on the left side of the machine. 2. Maintain the oil between the LOW and FULL marks on dipstick (1) at LOW IDLE with the oil at operating temperature.3. Remove oil fill plug (2) and add oil if necessary.4. Clean and install the fill plug.Replace filter element if transmission oil filter indicator comes on during operation. See the topic Transmission System under Every 250 Service Hours or Monthly in the Maintenance section of this manual.5. Close the access cover. When operating on severe slopes, quantity of oil in the power train system can be increased up to 10 percent. When operating with the increased oil quantity, prolonged operation in some machine positions can cause high power train oil temperatures. After work on severe slopes has been completed, remove excessive oil quantity from the power train compartment.Hydraulic Tank
Check Oil Level
The hydraulic oil tank is located on the right rear of the machine. 1. Maintain the oil level to the FULL mark in the sight gauge. 2. Remove the oil fill cap and add oil, if necessary, through the fill tube.3. Clean and install the fill cap.Radiator
Check Coolant Level
1. Remove the radiator cap slowly to relieve pressure.2. Maintain the coolant level to within 1 cm (.50 in) of the bottom of the fill pipe. If it is necessary to add coolant daily, check for leaks.3. Inspect the cap and cap seal for damage, deposits or foreign material. Clean the cap with a clean cloth or replace the cap if it is damaged.4. Install the cap.5. Inspect the radiator core for debris and clean if necessary.Compressed air is preferred, but high pressure