CAP 5043838 - Caterpillar

Table 1
Qty     Part Number     Part Description    
1     227-6715     Stud    
1     349-7078     Heat Shield    
1     417-5555     Bracket As    
1     5P-4116     Hard Washer    
2     6V-7357     Bolts    
8     8T-4121     Hard Washers    
2     8T-4133     Nuts    
3     8T-4137     Bolts    
1     8T-4189     Bolt    
2     9X-8256     Washers    The change is effective at the factory with C9N01415-UP, on 7November 2012. Installation Procedure
Illustration 1 g03302797
Remove the current 6V-1820 Bolt and 6V-5839 Washer from the 350-0214 Engine Cover Gp. Refer to Illustration 1.
Illustration 2 g03301396
(1) 311-5977 Cover (2) 227-6715 Stud (3) 8T-4121 Hard Washer
Install stud (2) with washer (3) through cover (1). Refer to Illustration 2. Tighten the stud.
Illustration 3 g03301617
(3) 8T-4121 Hard Washer
Install two washers (3) onto studs. Refer to Illustration 3.
Illustration 4 g03302518
(3) 8T-4121 Hard Washer (4) 8T-4137 Bolt (5) 349-7078 Heat Shield (6) 8T-4133 Nut
Install bolt (4) with washer (3) through the bracket (7) in order to secure the bracket to the cylinder head. Install nut (3) with washer (6) onto the stud in order to secure the heat shield to the stud.
Illustration 5 g03302957
Bottom view of cover and clip (7) 417-5555 Bracket As (8) 2Y-5829 Nut (9) 6V-5839 Washer
Install bracket (7) onto the left stud that secures the cover. Install nut (8) with washer (9) onto the stud.Note: Do not tighten the nut until the water lines are attached to the bracket.