CAP 5294876 - Caterpillar

Personal injury can result from rotating and moving parts. Stay clear of all rotating and moving parts.Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.The machine must be parked on a level surface and the engine stopped.Attach a "Do Not Operate" or similar warning tag to the start switch and controls before servicing, repairing, or making adjustments to the machine.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Drive the machine to a smooth, horizontal surface.
Illustration 1 g01376678
Move propulsion lever (1) to the NEUTRAL position.
Illustration 2 g01376692
Move parking brake switch (2) to the ON position.
Illustration 3 g01377821
Move throttle lever (3) to the LOW IDLE position.
Illustration 4 g01376707
Move engine start switch (4) to the OFF position.
Illustration 5 g01376709
Unhook latch (5) on each side of the machine, and open the engine compartment.
Illustration 6 g01376714
Install hood prop rod (6) .
Illustration 7 g01376718
Remove two nuts (7) and remove bracket (8). Slowly remove hydraulic tank cap (9) .
Illustration 8 g01376723
The hydraulic tank is not pressurized. If the pressure is released when cap (9) is removed, inspect breather (10). If necessary, the cap should be replaced.
Install cap (9). Replace plate (8) and install two nuts (7). Close the engine compartment.