CAP 6J5734 - Caterpillar

Introduction
The problem that identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
The fan pump drain line hose and pilot line hose may leak due to wear from interference.Solution
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
In the event of failure, replace the hoses with the same part number. Replace the existing clips with the new design during the repair.Required Parts
Table 1
Required Parts
Item Qty Part Number Part Name
1 1 265-0093 Hose As
2 1 227-0727 Hose As
3 3 5P-7464 Clip
4 3 5P-7465 Clip
5 3 8T-2920 Grommet
6 1 171-2637 Boss
7 1 8T-4136 Bolt
8 1 8T-4910 Bolt Rework Procedure
Illustration 1 g06356075
(A) 265-0093 Hose As
(B) 227-0727 Hose As
(C) 6V-1889 Clip
(D) 5D-0718 Clip
(E) 8T-4137 Bolt
(F) 8T-4192 Bolt
Remove failed hoses (A) and (B), clips (C) and (D), and bolts (E) and (F).
Illustration 2 g06356087
(1) 265-0093 Hose As
(2) 227-0727 Hose As
(3) 5P-7464 Clip
(4) 5P-7465 Clip
(5) 8T-2920 Grommet
(7) 8T-4136 Bolt
Illustration 3 g06356094
(3) 5P-7464 Clip (qty 2)
(4) 5P-7465 Clip (qty 2)
(5) 8T-2920 Grommet (qty 2)
(6) 171-2637 Boss
(8) 8T-4910 Bolt
Install new hoses (1) and (2), clips (3) and (4), grommets (5), boss (6), and bolts (7) and (8).
Tighten hoses (1) and (2) to a torque of 160 16 N m (118.0 11.8 lb ft).