CAP-CRANKSHAFT BEARING 6N8003 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     131-1525     Camshaft Pilot     1    Start By:
Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
Remove the front cover. Refer to Disassembly and Assembly, "Front Cover - Remove".
Remove the camshaft position sensor. Refer to Disassembly and Assembly, "Engine Sensors - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Turn the crankshaft to top center compression stroke for the No. 1 piston. Install the timing bolt in the flywheel. This is for timing during installation.
Ensure that the timing marks on the following gears are aligned: the camshaft drive gear, the idler gear and the crankshaft gear.
Illustration 1 g00529917
Note: It is not necessary to remove the cylinder head for removal of the camshaft.
Wire the valve lifters away from the camshaft. See Illustration 1.
Illustration 2 g00813405
Remove thrust pin (1) .
Install Tooling (A) into camshaft (2) .Note: Lubricate Tooling (A) for easier removal of the camshaft. Lubrication also prevents damaging the camshaft lobes and the camshaft bearings.
Carefully remove camshaft (2) from the engine.