CAP-ROLLER IDLER 6T4965 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-2320 Puller 1 Start By:
Remove the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01266942
Install the legs of Tooling (A) behind crankshaft front seal (1). Install a suitable spacer (2) between Tooling (A) and crankshaft (3). Use Tooling (A) in order to pull the crankshaft front seal out of the front housing. Note: Do not damage the bore for the crankshaft front seal in the front housing.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
B 9U-6210 Front Seal Installer 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the bore for the crankshaft front seal in the front housing is clean and free from damage.
Illustration 2 g01266453
Typical example
Assemble Tooling (B).
Align a new crankshaft front seal (1) to the front housing.
Use Tooling (B) to install crankshaft front seal (1). Ensure that the front face of the seal is installed to a depth of 9 0.2 mm (0.354 0.008 inch) into the front housing.
Remove Tooling (B) from the crankshaft. End By:
Install the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".