CAP-BEARING 7T4966 - Caterpillar

Illustration 1 g01616336
Right side view
Typical example
Illustration 2 g01616353
Front view
Typical example
Use the following tightening sequence for the clamp bolts:
Snugly tighten the clamp assembly (3) to the tube (4).
Tighten two bolts (2) of the clamp assembly to the elbow (10) to 47 9 N m (35 7 lb ft).
Tighten two bolts (1) of the clamp assembly to the tube (4) to 47 9 N m (35 7 lb ft). Note: The cooling jet sequence valves must start to open at a pressure difference of 130 30 kPa (19.0 4.5 psi).Note: The cooling jet sequence valves must be fully open at a pressure difference of 200 30 kPa (29.0 4.5 psi). (5) 6B-9202 Spring for the cooling jet sequence valve Quantity ... 2Length under test force ... 68.3 mm (2.69 inch)Test force ... 85 to 102 N (19 to 23 lb)Free length after test ... 112.7 mm (4.44 inch)Outside diameter ... 24.60 mm (0.969 inch)Note: The oil cooler bypass valve must open with a pressure difference of 180 20 kPa (26 3 psi). (6) 2W-1635 Spring for oil cooler bypass valve Length under test force ... 102.0 mm (4.02 inch)Test force ... 518 26 N (115.0 5.8 lb)Free length after test ... 143.4 mm (5.65 inch)Outside diameter ... 37.251 mm (1.4666 inch) (7) Lubricate the bore of the O-ring seals lightly with the clean engine oil. (8) Lubricate the bore of two O-ring plugs lightly with the clean engine oil. (9) Torque for the plug ... 100 15 N m (75 11 lb ft)