CAP 7V2744 - Caterpillar

warnings, and instructions must be read and understood before you perform any operation or any maintenance procedure.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed. When Required
Circuit Breakers - Reset
Cutting Edges and End Bits - Inspect/Replace
Engine Air Filter Primary Element - Clean/Replace
Engine Air Filter Secondary Element - Replace
Engine Air Precleaner - Clean
Ether Starting Aid Cylinder - Replace
Fuses - Replace
Oil Filter - Inspect
Radiator Core - Clean
Radiator Pressure Cap - Clean/Replace
Ripper Tip and Shank Protector - Inspect/Replace
Every 10 Service Hours or Daily
Backup Alarm - Test
Brakes, Indicators and Gauges - Test
Cooling System Level - Check
Engine Oil Level - Check
Fuel Tank Water and Sediment - Drain
Hydraulic System Oil Level - Check
Seat Belt - Inspect
Transmission Oil Level - Check
Walk-Around Inspection
Every 50 Service Hours or Weekly
Bulldozer Cylinder Support Bearings - Lubricate
Ripper Linkage and Cylinder Bearings - Lubricate
Sprocket Hub Bearings - Inspect
Track Pins - Inspect
Track Roller Frame Bearings - Lubricate
Transmission Oil Filter and Screens - Replace/Clean
Every 100 Service Hours or 2 Weeks
Hydraulic Control Linkage - Lubricate
Every 250 Service Hours or Monthly
Alternator and Fan Belts - Inspect/Adjust/Replace
Battery - Inspect
Battery - Recycle
Battery, Battery Cable or Battery Disconnect Switch - Replace
Braking System - Test
Bulldozer Tilt Brace - Lubricate
Cooling System Additive - Add
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Final Drive Oil Level - Check
Track Adjustment - Adjust
Transmission Magnetic Screen - Clean
Transmission Oil Filter - Replace
Every 500 Service Hours or 3 Months
Engine Crankcase Breather - Clean
Equalizer Bar Pads - Inspect/Replace
Fuel System Primary Filter - Clean/Replace
Fuel System Secondary Filter - Replace
Fuel System - Prime
Fuel Tank Cap and Strainer - Clean
Hydraulic System Oil Filter - Replace
Sprocket Hub Bearings - Inspect
Every 1000 Service Hours or 6 Months
Drive Shaft Universal Joint - Lubricate
Rollover Protective Structure (ROPS) and Falling Object Protective Structure (FOPS) - Inspect
Transmission Oil - Change
Transmission Oil Filter and Screens - Replace/Clean
Every 2000 Service Hours or 1 Year
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Final Drive Oil - Change
Hydraulic System Oil - Change
Sprocket Hub Bearings - Adjust
Transmission Oil - Change
Transmission Oil Filter and Screens - Replace/Clean