CAP 8R7074 - Caterpillar

Machine Stopping
Park on a level surface. If it is necessary to park on a grade, block the wheels securely.Do not engage the parking/secondary brake while the machine is moving unless an emergency exists.
1. Apply the service brakes to stop the machine. 2. Move the transmission control lever to NEUTRAL. 3. Push the knob in to engage the transmission neutral lock. 4. Pull the lever up to engage the parking/secondary brake.5. Lower the bucket to the ground and apply slight down pressure.Engine Stopping
1. With the machine stopped, run the engine for 5 minutes at low idle. This can help extend engine life. 2. Pull the accelerator pedal back past the detent to stop the engine. Turn the start key switch to OFF. Remove the key.Leaving the Machine
1. Use the steps and handholds, use both hands and face the machine, when dismounting. 2. Drain the moisture from the air tank daily. 3. Inspect the engine compartment for debris. Clean out any debris and paper to avoid a fire.4. Remove all flammable debris from front bottom guard through the access doors to reduce fire hazard.5. If the machine is being parked for an extended period (overnight, etc.), turn off the disconnect switch and remove the key.6. Install all vandalism protection locks and covers.Machine Lifting/Tiedown Information
Improper lifting or tiedowns can allow load to shift and cause injury or damage.
1. Weight and instructions given herein apply to units manufactured by Caterpillar Inc.950E Weight 15 856 kg (34,883 lb)2. Use proper rated cables and slings for lifting. Position crane for level machine lift.3. Spreader bar widths should be sufficient to prevent contact with machine.4. Use two rear and two front holes provided for tiedown.Install tiedowns at several locations, and block wheels front and rear.Check state and local laws governing weight, width and length of load.Contact your Caterpillar dealer for shipping instructions for your machine.