CAP (trans. oil filter) 9D6161 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Description Qty
A 1P-0068 Cone 1
1P-0069 Head 1
1P-0071 Jaws 3
8K-8466 Push Rod
(5/8 - 18 by 12 inch) 1
1A-8285 Jam Nuts
(5/16 - 24) 3
6H-0187 Bolts
(5/16 - 24 by 1 1/8 inch) 3
1P-5546 Crossarm 1
5P-8247 Hard Washer (3.5 mm by 32 mm) 1
1B-4206 Nut
(5/8 - 18) 1
B 3B-2968 Bolts
(3/4 - 10 by 3 1/2 inch) 3
C 5P-8622 Clevis 1
8T-3207 C- Frame Lifting As 1
1A-8063 Bolts
(3/4 - 10 by 2 1/2 inch) 2
5P-8248 Hard Washers (3.5 mm by 36.5 mm) 6
1B-4331 Nuts
(3/4 - 10) 2
D 1P-0520 Driver Gp 1
Illustration 1 g00617864Note: Orient the lip of the seal toward the inside of the hub.
Use Tooling (D) to install lip seal (8) in the spindle.
Apply clean oil to the lip of seal (8).
Illustration 2 g00617863
Apply a small amount of grease to the back of thrust ring (7) to hold the thrust ring in place.
Install thrust ring (7).
Illustration 3 g03390489
Install inner sun gear (4) in planetary carrier (2).
Install Tooling (A) to hold sun gear (4) in place.
Install O-ring seal (5) and O-ring seal (6).
Illustration 4 g03389280
Attach Tooling (C) and a suitable lifting device to planetary carrier (2). The weight of planetary carrier (2) is approximately 209 kg (460 lb).
Install planetary carrier (2) on the hub.
Align the gears and slide planetary carrier (2) in the hub.
Push the planetary carrier (2) until planetary carrier (2) is 25 mm (1.0 inch) from the hub.
Thread Tooling (B) 25 mm (1.0 inch) in the hub. Install Tooling (B) so that the three bolts are spaced equally.
Remove Tooling (C).
Illustration 5 g00617850
Install bolts (3).
Remove Tooling (B).
Install remaining bolts (3).
Tighten bolts (3) to a torque of 430 60 N m (320 45 lb ft).
Remove Tooling (A).
Fill the final drive with oil. See the procedure in Operation and Maintenance Manual, SEBU6891, "Final Drive Oil Level - Check". End By:
Install the axle.