AVSPARE.COM
parts catalog

CARRIER ASSEM. 4" 0000015 - Caterpillar



0000015 CARRIER ASSEM. 4" Caterpillar parts D343 CARRIER
Rating:
44
Alternative (cross code) number:
CA0000015
000-0015
0000015
Caterpillar 0000015 CARRIER ASSEM. 4"

Buy CARRIER ASSEM. 4" 0000015 Caterpillar genuine, new aftermarket tractor parts with delivery
MARINE ENGINE,

You can buy parts: .

$28.34

23 Apr 2021

CN: Shenzhen Taida Century Technology Co.,Ltd.
1 pc OPA1611 Module Low Power Precision op amp Audio Dedicated Audio Amplifier
Taidacent Name: Low Power Precision Operational Amplifier Audio Dedicated Preamp Size: 50mm X 50mm Supply voltage range: up to ±18V || Can be arbitrarily changed to positive amplification, reverse amplification, shooting with the integration circuit and other forms. The OPA1611 is ultra-low noise and is a powerful audio system. || The main features Excellent sound quality Ultra-low noise: 1.1nv/vHz at 1kHz Ultra low distortion: 0.000015% 1kHz High conversion rate: 27V/H Bandwidth: 40MHz (G=+1) Open loop gain: 130dB Unity gain stability Low quiescent current: 3.6 per channel Rail-to-rail output Wide Supply Range: ±2.25V to ±18V || Application Professional audio equipment Analog and digital mixing console Audio Test and Measurement Preamplifiers microphone Broadcast recording equipment High-end A/V receiver || The opa1611 bipolar input op amps achieve a low 1.1nv/VHz noise density at ultra-low distortion Hz of 0.000015% at 1kHz. The opa1611 provide a rail-to-rail output swing with a 2K2 load at 600mV, thereby increasing headroom and maximum dynamic range.

06 Apr 2017

GSS: GSS
GSS Digital Magnetic Stirrers 0000015

06 Apr 2017

GSS: GSS
GSS 2.5V Halogen Otoscope Standard 0000015
Number on catalog scheme: None
  
  For full view, you need register

Compatible equipment models: 0000015:

MARINE ENGINE  D343   Caterpillar

Information:


Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger damage can result if the engine rpm is not kept low until the oil gauge display verifies that the oil pressure is sufficient.
The engine start switch will not engage the starter unless the following conditions exist:
The engine speed is 0 rpm.
The prelubrication of the engine (if equipped) is complete or the prelubrication system is overridden.Note: If the machine must be started immediately, the engine prelubrication system can be overridden. Return the key to the OFF position in order to stop the prelube cycle and then turn the key back to the START position in order to immediately start the engine. If the key is not turned back to the START position within 6 seconds after the prelube cycle is terminated, the override feature will expire. If the prelube cycle is overridden, the engine ECM will log a prelube override event.Note: The engine prelubrication system will not activate if the engine has been stopped for less than 2 minutes.Note: The prelube cycle will run until one of the following conditions are met:
The engine prelubrication system is active for 45 seconds.
the engine oil pressure reaches 48 kPa (7 psi).
Illustration 1 g03663187
Make sure that the shift control lever (3) is in the P position and the park brake indicator (2) is illuminated.
Adjust the operator seat. Adjust the mirrors.
Fasten the seat belt.
The dump body should be down.
Make sure that no additional personnel are on the machine, underneath the machine or around the machine. Make sure that there are no additional personnel in the area.
Sound horn (4) and allow adequate time for bystanders to clear the area. Follow local practices for your machine application.
Turn engine start switch (1) to the ON position. The Advisor system will perform a self test.
Turn the engine start switch to the START position and hold the engine start switch to the START position. Note: If equipped, the prelubrication system will activate.Note: Do not depress the accelerator control.
Release the engine start switch when the engine starts. Note: If the engine does not start, return the engine start switch to the OFF position before you attempt to start the engine again.Note: For starting below −18 °C (0 °F), use of additional cold weather starting aids is recommended. A coolant heater, a fuel heater, or extra battery capacity may be required. At temperatures below −23 °C (−10 °F), consult your Cat dealer or refer to the Special Publication, SEBU5898, "Cold Weather Recommendations".Engine Block Heater (If Equipped)
To avoid shocks or other injuries, never use an ungrounded or inadequate extension cord. Use a three-wire extension cord with a three-wire plug which is rated for at least a 15 amp load and is protected by a suitable fuse or circuit breaker.Always inspect the heater electrical cord for worn or frayed insulation before plugging into current.
A 240 volt engine block heater warms the engine coolant and the engine oil in order to aid starting.

Caterpillar parts catalog:

Caterpillar parts catalog
D343 MARINE ENGINE 33B00001-00677


Parts carrier Caterpillar catalog:

3N8477 CARRIER
3406, 3408, 953, D343
4L3215 CARRIER ASSEM.
3406, D333A, D337F, D342, D342C, D343
5L6574 CARRIER ASSEM.
3406, 3408, D333A, D342, D342C, D343
3N4816 CARRIER
3406, 3408, D342, D342C, D343
2N2197 CARRIER
D346, D348, D353C
3N7403 CARRIER ASSEM.
D342C, D348, D353C, D398, D399
3N4816 CARRIER
3406, 3408, D342, D342C, D343
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.