CARRIER-WEIGHT 1327444 - Caterpillar

There are several specific messages on these machines. The exact location of the messages and the description of the messages are reviewed in this section. Please become familiarized with all messages.Make sure that all of the messages are legible. Clean the messages or replace the messages if the words or images are unreadable. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. Loose adhesive will allow the messages to fall.Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part. Any Caterpillar dealer can provide new messages.
Illustration 1 g01233415
This illustration shows one type of enclosed generator set.
Illustration 2 g01233280
This illustration shows another type of enclosed generator set.
Illustration 3 g01233028
This illustration shows an open generator set.
Illustration 4 g01239864
Typical example of a fuel tankLifting point (1)
Illustration 5 g01034418
Lift the package from this point. Refer to the following topic:
Operation and Maintenance Manual, "Product Lifting"Rating for lifting equipment (2) This message is located on the side of the enclosure near the bottom of the enclosure.
Illustration 6 g01233472
The lifting equipment that is used for lifting this type of generator set must be rated for a total weight of 3000 kg (6,600 lb).Rating for lifting equipment (3) This message is located on the side of the enclosure near the bottom of the enclosure.
Illustration 7 g01233040
The lifting equipment that is used for lifting this type of generator set must be rated for a total weight of 4000 kg (8,800 lb).Rating for lifting equipment (4) This message is located on the side of open generator sets on the base.
Illustration 8 g01233043
The lifting equipment that is used for lifting this type of generator set must be rated for a total weight of 3000 kg (6,600 lb).Fuel tank vent (5) This message is located on the fuel tank by the vent.
Illustration 9 g01239683
This generator tank has been pressure tested at 20.6 kPa (3 psi) to 34.5 kPa (5 psi) for weld integrity. However, it has not been designed as a pressure vessel and must be vented from supplied openings. This tank was designed, manufactured and intended for diesel fuel