CARRIER AS-D 1608518 - Caterpillar

Parameter Descriptions
"Product Sales Model"
The "Product Sales Model" parameter allows the customer to enter the correct sales model into the ECM so that the ECM will know the correct power setting to apply for the application."Equipment ID"
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field."Engine Serial Number"
Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM."FLS" (Full Load Setting)
"FLS" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or if a new ECM is installed. The parameter allows one time of programming without a factory password. In order to change the "FLS" after the initial programming, factory passwords are required."FTS" (Full Torque Setting)
"FTS" is similar to "FLS". Only change this value if the engine is rerated or if a new ECM is installed. Factory passwords are required. A new ECM or a blank ECM allows one time of programming of the "FTS" without the use of factory passwords. In order to change the "FTS" after the initial programming, factory passwords are required."Engine Warmup Elevated Idle"
The "Engine Warmup Elevated Idle" parameter allows the operation of this feature to be enabled or disabled."Ether Solenoid Configuration"
The parameter for the "Ether Solenoid Configuration" allows the ether solenoid to be installed or not installed."Security System Immobilizer Installation Status"
The "Security System Immobilizer Installation Status" allows the "security system immobilizer" to be installed or not installed."Injector Trim File"
This parameter is for the injector trim files that are associated with each injector. If an injector is replaced or if two injectors are exchanged between cylinders, the injector trim file for the injector must be programmed to the correct cylinder.Parameter Table
Table 2
Customer Specified Parameters
Parameter Available Range or Options Default Required Password
"Product ID" 8 characters blank none
"Equipment ID" 17 characters blank none
"Engine Serial Number" 8 characters blank none
"ECM Serial Number"
Software Group Part Number
Software Group Release Date
Software Group Description
"Product Sales Model" "140K" or "160K" Factory
"Ether Solenoid Configuration" "Not Installed" or "Continuous Flow Solenoid" "Continuous Flow Solenoid" none
"Security System Immobilizer Installation Status" "Installed" or "Not Installed" "Not Installed" none
"Engine Warmup Elevated Idle" "Enabled" or "Disabled" "Enabled" none
"FLS" -128 to +127 0 Factory
"FTS" -128 to +127 0 Factory Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 3
Information from ECM
"Product ID"
"Equipment ID"
"Engine Serial Number"
"ECM Serial Number"
"Personality Module Part Number"
"Personality Module Release Date"
"Personality Module Description"
"FLS"
"FTS"
"Engine Warmup Elevated Idle"
"Ether Solenoid Configuration"
"Security System Immobilizer Installation Status"
"Total Tattletale"
Information From Engine Information Plate
Engine Serial Number
Full Load Setting
(for new ECM)
Full Torque Setting
(for new ECM)
Injector Code (1)
Injector Code (2)
Injector Code (3)
Injector Code (4)
Injector Code (5)
Injector Code (6)
Note: Compare the FLS and the FTS from the ECM