CARRIER-STATOR 1T2023 - Caterpillar

Illustration 1 g01738453
Left side view (1) High pressure fuel pump (2) Fuel rail (3) Pressure relief valve for fuel rail (4) Coil for the ARD purge air actuator (5) Engine Control Module (ECM) (6) Optional hand priming pump (7) Secondary fuel filter (8) Pilot fuel control valve (9) Main fuel control valve (10) Air inlet heater relay (11) Air compressor (12) Fuel enable valve (13) Cleaning port for the Aftertreatment Regeneration Device (ARD) (14) Fuel transfer pump
Illustration 2 g01738515
Right side view (15) Venturi for the combustion air supply (16) CGI control group (17) Venturi for the CGI system (18) Ignition coil (19) Oil filter (20) CGI precooler (21) Variable Nozzle Turbocharger (VNT) (22) Flywheel housing (23) ARD Body (24) ARD combustion head (25) Spark plug (26) Aftertreatment Regeneration Device (ARD) (27) Air pressure control valve
Illustration 3 g01523650
Right side view of the Diesel Particulate Filter (DPF) (28) Inlet to the DPF (29) Outlet for CGI (30) Outlet from the DPFThe engine is a in-line six cylinder engine. The firing order of the engine is 1-5-3-6-2-4. The engine's rotation is counterclockwise when the engine is viewed from the flywheel end of the engine. The engine utilizes a turbocharger and an air-to-air aftercooler. The engine has a bore of 115.0 mm (4.53 inch) and a stroke of 149.0 mm (5.87 inch). The displacement is 9.3 L (568 cu in ).The fuel system eliminates many of the mechanical components that are used in a pump-and-line system. The fuel system also provides increased control of the timing and increased control of the fuel air mixture. The timing advance is achieved by precise control of the fuel injector timing. Engine rpm is controlled by adjusting the injection duration. A special pulse wheel provides information to the ECM for detection of cylinder position and engine rpm.The engine has built-in diagnostics in order to ensure that all of the components are operating properly. In the event of a system component failure, the operator will be alerted to the condition via the check engine light that is located on the dashboard. An electronic service tool can be used to read the numerical code of the faulty component or condition. Also, the cruise control switches can be used to flash the code on the check engine light. Intermittent faults are logged and stored in memory.Starting The Engine
The engine's ECM will automatically provide the correct amount of fuel in order to start the engine. Do not hold the throttle down while the engine is cranking. If the engine fails to start in twenty seconds, release the starting switch. Allow the starting motor to cool for two minutes before the starting motor is used again.
Excessive ether (starting fluid) can cause piston and ring damage. Use ether for cold weather starting purposes only.
Cold Mode Operation
Starting the engine and operation in cold weather is dependent on the type of fuel that is used, the oil viscosity, and other optional starting aids. For more information, refer to the Operation and Maintenance Manual, "Cold Weather Operation".