CARRIER-PLANET 20R4215 - Caterpillar

You must read and understand the warnings and instructions contained in the Safety section of this manual before performing any operation or maintenance procedures.Walk-Around Inspection
Inspect Machine
See "Walk-Around Inspection" in the "Before Starting the Engine" section.Cleaning Windows
Use commercially available window cleaning solutions to clean the windows.Lift the latch to slide the window open.Cooling System
Look at the Coolant Level
The radiator cap is located on the front of the machine. 1. Open the access door in the hood. 2. Remove the radiator cap slowly to relieve pressure. 3. Maintain the coolant level to within 1 cm (1/2 in) of the bottom of the fill pipe. If it is necessary to add coolant daily, check for leaks.4. Inspect the cap seal. Replace the cap if it is damaged.5. Install the cap. Close the access door.Engine Crankcase
Measure the Oil Level
Do not overfill the crankcase to avoid engine damage.
1. Open the access door in the hood of the machine. 2. Maintain the oil level between the ADD and FULL marks on the dipstick (1).3. Remove the oil fill plug (2) and add oil if necessary.4. Clean and install the fill plug.5. Close the access door.Fuel Tank
Drain the Moisture and Sediment
Drain valve is located under the fuel tank. 1. Open the drain valve and allow the moisture and sediment to drain.2. Close the drain valve.Back-up Alarm
Test For Proper Operation
1. With the disconnect switch on, apply the services brake and place the transmission control lever in REVERSE.2. The alarm should start to sound immediately. It will continue to sound until the transmission selector lever is moved to NEUTRAL or FORWARD.Seat Belt
Inspect for Wear or Damage
Always check condition of seat belt and mounting hardware before operating machine. Replace any damaged or worn parts.Replace the seat belt after three years of usage, regardless of appearance. Seat belt and mounting hardware must be inspected for wear or damage. Replace the belt or mounting hardware if worn or damaged.Indicators, Gauges, Lights and Horn
Test for Proper Function
1. Look for broken gauge lenses or indicator lights, switches, etc.2. Start the engine. 3. Look for inoperative gauges. 4. Turn all machine lights on. Check for proper operation. 5. Sound horn.6. Stop the engine.7. Make any needed repairs.Hydraulic Tank
Check the Oil Level
The hydraulic oil tank is located on the right rear of the machine. 1. Maintain the oil level to the FULL mark in the sight gauge (2).2. Remove the oil fill cap (1), if necessary, to add oil through the fill tube.All implements to be level and on the ground during filling.Winch (If Equipped)
Check Oil Level and Wire Rope Cable
1. Start the engine and run at low idle. 2. The oil must be visible in the sight gauge. 3. Remove the oil fill plug and add oil if necessary. 4. Stop the engine. 5. Check the wire rope cable. Replace it if worn, frayed or damaged.Transmission
Measure the Oil Level
The transmission oil dipstick is located in the operator compartment under the floor access plate in front of the operator's seat. 1. Maintain the