CARRIER AS 2460151 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     FT-1114     Vacuum Cap     1    Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00910597
Install Tooling (A) on the hydraulic tank. Attach hose (1A) to the nipple on Tooling (A) and to an air supply. Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull a vacuum on the hydraulic system.
Illustration 2 g01011875
Disconnect harness assembly (1) .
Disconnect hose assemblies (2) .
Disconnect tube assembly (3) .
Disconnect hose assembly (4) .
Remove the solenoid valve and manifold (5) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     FT-1114     Vacuum Cap     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 3 g01011875
Install the solenoid valve and manifold (5) .
Connect hose assembly (4) .
Connect tube assembly (3) .
Connect hose assemblies (2) .
Connect harness assembly (1) .
Illustration 4 g00910597
Remove Tooling (A) from the hydraulic tank.
Fill the implement hydraulic system. Refer to the appropriate Operation and Maintenance Manual for the correct procedure.