CARRIER-RING 3351160 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-9200     Lever Puller Hoist     1    Start By:
Remove the dash panel. Refer to Disassembly and Assembly, "Dash Panel - Remove".
Remove the radiator guard and the radiator. Refer to Disassembly and Assembly, "Radiator Guard and Radiator - Remove".
Remove the middle and the rear bottom guard. Refer to Disassembly and Assembly, "Bottom Guard - Remove".
Remove the drive shaft. Refer to Disassembly and Assembly, "Driveshaft - Remove".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the hydraulic tank into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".
Illustration 1 g01308313
Illustration 2 g01311450
Disconnect hose assemblies (1) and (2) .
Illustration 3 g01311451
Illustration 4 g01311452
Disconnect cable assembly (4). Disconnect harness assemblies (3) and (5). Disconnect hose assembly (6). Disconnect cable assembly (7). Remove bolts (8) .
Illustration 5 g01308314
Remove the bolt and clip (9). Lay harness assemblies aside.
Illustration 6 g01311867
Illustration 7 g01311869
Disconnect hose assemblies (10) and (11).
Illustration 8 g01311933
Disconnect hose assemblies (12). Disconnect harness assembly (13) .
Illustration 9 g01311873
Illustration 10 g01311983
Illustration 11 g01311877
Attach Tooling (A) and a suitable lifting device to engine (15). The weight of engine (15) is approximately 1588 kg (3500 lb). Remove bolts (14) and (16) .