AVSPARE.COM
parts catalog

CARRIER-PLNTY-YM 3905269 - Caterpillar



3905269 CARRIER-PLNTY-YM Caterpillar parts CARRIER
Rating:
9
Alternative (cross code) number:
CA3905269
390-5269
3905269
Caterpillar 3905269 CARRIER-PLNTY-YM
Weight: 35 pounds 15 kg.

Buy CARRIER-PLNTY-YM 3905269 Caterpillar genuine, new aftermarket tractor parts with delivery

Related part:
6T3726  CARRIER-PLNTY-YM  3905269  CL
  For full view, you need register

Information:

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     6V-9120     Socket (1)     1    
( 1 ) Tool (A) is a 46 mm socket.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
When the connecting rod caps are installed, ensure that the identification marks are aligned.
Note: The clearance between the connecting rod bearing and a new crankshaft should be 0.030 to 0.090 mm (0.0012 to 0.0035 inch). The clearance between the connecting rod bearing and a used crankshaft should be no greater than 0.200 mm (0.0079 inch). Install the connecting rod bearings dry when the clearance checks are made. Refer to Disassembly and Assembly, "Bearing Clearance - Check" for information on bearing clearance checks.
Illustration 1 g00586406
Clean the bearing surface of connecting rod (5) and connecting rod cap (2). Ensure that the number on connecting rod cap (2) matches the number on connecting rod (5) .
Clean upper connecting rod bearing (4) and lubricate the bearing face with clean engine oil.
Clean lower connecting rod bearing (3) and lubricate the bearing face with clean engine oil.Note: Align the tabs on the back of the connecting rod bearings with the tab grooves in the connecting rod.
Use Tool (A) to rotate the crankshaft until two of the connecting rod journals are at the bottom center. Install upper connecting rod bearing (4) in connecting rod (5) .
Pull connecting rod (5) into position against the crankshaft.
Install lower connecting rod bearing (3) in connecting rod cap (2) .
Put clean engine oil on the connecting rod bolts.
Illustration 2 g00534937
Install two nuts (1) on connecting rod cap (2). Tighten the connecting rod nuts to a torque of 54 5 N m (40 4 lb ft).
Repeat Steps 1 through 8 for the installation of the remaining connecting rod bearings.End By: Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".


Parts carrier Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.