CARRIER-PLANETARY 3V2065 - Caterpillar

The 3306B Industrial Engine provides the following features:
Mechanical fuel system
Six cylinders
Two valves per head
Direct fuel injection
Turbocharging
Air-to-air aftercooling (ATAAC)The cooling system consists of the following components:
Gear driven centrifugal pump
Water temperature regulator (one) which regulates the engine coolant temperature
Engine oil cooler
Radiator which incorporates a shunt systemEngine Specifications
Note: The front end of the engine is opposite the flywheel end of the engine. The left and the right side of the engine are determined from the flywheel end. The number 1 cylinder is the front cylinder.3306B Industrial Engine
Illustration 1 g00316303
Cylinder and Valve Locations
(A) Exhaust Valves
(B) Inlet Valves
Table 1
3306B Industrial Engine Specifications
Number of Cylinders 6 In-Line Cylinders
Bore 120.7 mm (4.75 inch)
Stroke 152.4 mm (6.0 inch)
Aspiration Turbocharged aftercooled(1)
Compression Ratio 17:1
Displacement 10.5 L (638 in3)
Firing Order 1-5-3-6-2-4
Rotation (viewed from flywheel) Counterclockwise
Valve Lash Setting (Inlet) 0.38 mm (.015 inch)
Valve Lash Setting (Exhaust) 0.64 mm (.025 inch)
(1) Air-to-air aftercooling (ATAAC)Engine Features
All emissions certified engines are equipped with an air/fuel ratio control that is located on the governor. The air/fuel ratio control restricts the fuel rack movement. Only the proper amount of fuel is allowed to be injected into the cylinders during acceleration. This fuel injection minimizes exhaust smoke.Emissions certified engines are equipped with tamperproof bolts in order to discourage tampering with the setting for the air/fuel ratio control. This is required by regulations for emissions. Changing the air/fuel ratio control could cause the engine to exceed standards for emissions.The engine is powered with direct fuel injection. A hydramechanical governor controls the fuel injection pump output in order to maintain the engine rpm that is selected by the operator.Fuel is metered and fuel is pumped to the fuel injection nozzles (one per cylinder) by a fuel injection pump that is under high pressure. The automatic timing advance provides the best fuel injection timing over the full range of engine rpm.The engine lubricating oil is supplied by a gear type pump. The engine lubricating oil is cooled and the engine lubricating oil is filtered. Bypass valves provide unrestricted flow of lubrication oil to the engine parts when oil viscosity is high. Bypass valves can also provide unrestricted flow of lubrication oil to the engine parts if the oil cooler should become plugged or if the oil filter element should become plugged.Engine efficiency, efficiency of emission controls, and engine performance depend on adherence to proper operation and maintenance recommendations. Engine performance and efficiency also depend on the use of recommended fuels, lubrication oils, and coolants. Refer to the Operation and Maintenance Manual, "Maintenance Interval Schedule" for more information on maintenance items.