Disconnect exciter stator wiring (11) . Remove bolts (10) and bracket assembly (8) . Illustration 6 g03361116 Remove ring (12) and O-ring seal (13) . Illustration 7 g03344273 Use Tooling (C) to remove bearing (14) .Installation Procedure Illustration 8 g03368022 Ensure that bearing cap (14) is installed and properly orientated.Note: Failure to install bearing cap (14) before the bearing is installed will result in removal of the bearing again. Illustration 9 g03344382 Note: Do not use any other method or process to raise the temperature of bearing (15) other than an induction heater or an oven. Do not rotate or impact the heated bearing. Raise the temperature of bearing (14) to a maximum of 149° C (300° F). Use Tooling (D) to install bearing (14) . Illustration 10 g03332042 Install ring (12) and O-ring seal (13). Apply a thin layer of Tooling (E) to the bearing cavity. Illustration 11 g03344401 Install Tooling (F) into bearing cap (15) . Illustration 12 g03332272 Attach Tooling (B) and a suitable lifting device to bracket assembly (8). Refer to Table 3 for the approximate weight of bracket assembly (8). Table 3 Approximate Weight of Bracket Assembly (8)     Model     Approximate Weight     LC 5     54 kg (119 lb)     LC 6     77 kg (170 lb)     LC 7     114 kg (251 lb)     Guide Tooling (F) through the bolt holes of bracket assembly (8). Position bracket assembly (8) and install bolts (10) . Connect exciter stator wiring (11) . Remove Tooling (B) . Illustration 13 g03332583 Remove Tooling (A) from between main rotor (7) and stator (9) surfaces. Illustration 14 g03342872 Remove one Tooling (F) and install one bolt (6). Remove other Tooling (F) and install other bolt (6) . Install outer bearing cover (5) . Illustration 15 g03344131 Install air inlet screen (4) . Illustration 16 g03332570 Install terminal panel (2) and lifting eye (3) . Install panel (1) . Connect the DC battery supply. Close the AC breaker.End By: Install optional permanent magnet pilot exciter ( PMG) attachment if equipped.