CARRIER-PLANET 5K0930 - Caterpillar

Introduction
Use the following procedure to calibrate the main pump.Required Tools
Illustration 1 g03261789
(D) 418-3611 Track Block
Table 1
Tool Item Part Number Description Qty
D 418-3611 Track Block 2 Machine Preparation
Position the machine on level ground.Note: Ensure to provide adequate clearance for machine movement.
Illustration 2 g06208095
(D) Track block
(1) Sprocket
Insert track blocks to the right and left travel motors.
Illustration 3 g06242211
(2) Solenoid valve for swing parking brake
(3) Connector
Disconnect swing brake solenoid connector.
Start the engine.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F). Refer to Testing and Adjusting, "Hydraulic System Warmup".Calibration Procedure
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Note: Machine movement is possible during main pump calibration.Monitor Procedure
Illustration 4 g06241492
Enter the "Service" menu on the monitor.
Enter password "9992".
Select "Calibration" menu.
Select "Electric-Hydraulic Valves".
Select "All Pumps with Pump Pressure".
Follow the instruction on the monitor to complete the calibrations.
If no error occurs, the calibration was complete successfully.ET Procedure
Select the ECM for "Machine Control".
Select "Calibrations" from the "Service" menu.
Select "Electric-Hydraulic Valves Calibrations".
Select "All Pumps with Pump Pressure Calibrations".
Select "Start".
Follow the instruction on the monitor to complete the calibrations.
If no error occurs, the calibration was completed successfully.Troubleshooting - Error Codes
If the calibration fails with the same error code three times, refer to the following tables, and replace the affected solenoid.
Table 2
Calibration Error Codes
Out of Range Low Out of Range High Inconsistent
Hydraulic Pump Displacement Inconsistent - - 0x11E7
Hydraulic Pump Discharge Pressure Too Low 0x120C - -
Left Pump Minimum Current $10D4 $10D5 -
Left Pump Maximum Current $10D6 $10D7 -
Right Pump Minimum Current $10DA $10DB -
Right Pump Maximum Current $10DC $10DD -
Table 3
Other Error Codes
Error Code
Implement Lockout Switch Off 0x1042
Implement Not in Hold Position 0x106A
Engine RPM too low 0x1074