CARRIER 7D2896 - Caterpillar

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Prepare the machine for maintenance. Refer to Operation and Maintenance Manual, "Prepare the Machine for Maintenance".
Illustration 1 g02005753
Remove screen cover (1) from the torque converter housing. Note: Some oil may be trapped behind the screen cover. Prepare a suitable container to collect any trapped oil.
Remove outlet screen (2).
Remove wave washer (5), magnetic tube assembly (4), and sump screen (3).
Wash the outlet screen, the sump screen and the magnetic tube assembly in clean, nonflammable solvent. Clean the magnets with a cloth, a stiff bristle brush or air pressure.
Install the clean magnetic tube assembly, the clean sump screen, and the wave washer.
Install the clean outlet screen.
Inspect the seals in the screen cover. Apply seal lubricant to hold the seals in place and prevent damage. If a seal is damaged, replace the seal.
Install the screen cover.
Start the engine and operate the engine at an idle. Check for leaks and make any necessary repairs.
Check the oil level in the torque converter sump. If necessary, add oil. For the proper procedure, refer to Operation and Maintenance Manual, "Torque Converter Sump Oil Level - Check".