CARRIER-PLANETARY 8E4024 - Caterpillar

System Operation Description:The probable causes of high fuel temperature
Associated codes
Fuel level in the tank
Fuel temperature sensor
Fuel return pressure regulator
Restriction in the fuel lines
Fuel injectorUse this procedure in order to troubleshoot high fuel temperature. Use this procedure if one of the following event codes is active. Access the engine monitoring system on Caterpillar Electronic Technician (ET) in order to view the current trip points for these codes. Refer to Troubleshooting, "Engine Monitoring Parameters" for information about engine events.
Table 1
Engine Events
J1939 Code and Description Conditions that Generate the Code System Response
174-0 Engine Fuel Temperature 1 : High - most severe (3) The fuel temperature is above an acceptable level. The code is logged.
174-15 Engine Fuel Temperature 1 : High - least severe (1)
174-16 Engine Fuel Temperature 1 : High - moderate severity (2) Test Step 1. Check for Active Diagnostic Codes
Check for active codes and check for logged codes on Caterpillar Electronic Technician (ET).
Check Cat ET for any associated codes that are listed in Table 2. Troubleshoot any active codes before continuing with this procedure.
Table 2
Associated Codes
J1939 Code Description
5580-17 Engine Filtered Fuel Delivery Pressure (After Secondary Filter Gauge): Low - least severity (1)
5580-18 Engine Filtered Fuel Delivery Pressure (After Secondary Filter Gauge): Low - moderate severity (2) Expected Result:There are no associated codes that are active or logged.Results:
OK - No associated codes are active or logged. Proceed to Test Step 2.
Not OK - There are associated codes that are active or logged.Repair: Troubleshoot any active codes before continuing with this procedure.STOPTest Step 2. Check the Fuel Level in the Fuel TankCheck the fuel level in the fuel tank.Expected Result:The fuel level in the tank is acceptable.Results:
OK - The fuel level is acceptable. Proceed to Test Step 3.
Not OK - The fuel level is not acceptable.Repair: Fill the tank. Verify that the problem has been resolved.If the problem has not been resolved, proceed to Test Step 3.Test Step 3. Inspect the Fuel Lines
Illustration 1 g02158580
Fuel lines for the engine (typical engine view)
Visually inspect the fuel lines between the priming pump and the inlet to the cylinder heads that are at the back of the engine. Inspect the fuel return line from