CARRIER 8V7984 - Caterpillar

Table 1
Parts List    
Quantity     Part Number     Description    
4     8T-4121     Washer    
4     8T-4195     Bolt    
4     9X-8250     Clip    
4     9R-2613     Boss    Installation Procedure
Refer to Service Manual module, RENR2038, "Disassembly and Assembly, 994D Wheel Loader Machine Systems", "Frame Lock Link - Connect" for instruction on preparing the 994D Wheel Loader for service. Refer to Service Manual module, SENR4755, "Disassembly and Assembly, 994 Wheel Loader Vehicle Systems", "Anti-Pivot Link - Install" for instruction on preparing the 994 Wheel Loader for service.
Turn the battery disconnect switches to the OFF position.
Personal injury or death can result from fumes, gases and ultraviolet rays from the weld arc.Welding can cause fumes, burn skin and produce ultraviolet rays.Keep your head out of the fumes. Use ventilation, exhaust at the arc, or both, to keep fumes and gases from your breathing area. Wear eye, ear and body protection before working.Protect yourself and others; read and understand this warning. Fumes and gases can be dangerous to your health. Ultraviolet rays from the weld arc can injure eyes and burn skin. Electric shock can cause death.Read and understand the manufacturer's instructions and your employer's safety practices. Do not touch live electrical parts.See "American National Standard Z49.1, Safety in Welding and Cutting" published by the American Welding Society.American Welding Society
2501 N.W. 7th Street
Miami, Florida 33125
See "OSHA Safety and Health Standards, 29 CFR 1910", available from U.S. Department of Labor.U.S. Department of Labor
Washington, D.C. 20210
Illustration 1 g00689007
(A) 250 5 mm (9.84 0.2 inch). (B) 650 5 mm (25.6 0.2 inch).
Illustration 2 g00687874
Left Side
Illustration 3 g00687877
Right Side
Weld four 9R-2613 Bosses to the crossmember. The dimensions are shown in illustration 1. Center the bosses on the crossmember. The positions are shown in the previous illustrations. Ground the welder close to the welding area. Allow the weld to cool and paint the welded area.
Remove the grease lines that are attached to the left and right "E" and "F" pins and attach the lines to the new bosses. The improved routing is shown in the previous illustrations.