CARRIER-PLANETARY 8X6828 - Caterpillar

Illustration 1 g06022736
Place a suitable container under the engine oil drain hose . Refer to the Operation and Maintenance Manual, "General Hazard Information" for information that pertains to containing fluid spillage.
Illustration 2 g06022740
Open drain valve (1) to drain the oil.
Allow the oil to drain.
Close the drain valve.
Remove filter element (2). Discard the used filter element.
Clean the filter housing base. All the old filter seal must be removed from the filter housing base.
Apply a thin coat of engine oil to the seal of the new filter elements.
Install the new filters by hand. When the seal contacts the base, tighten the filter element for an extra 3/4 turn. This extra turn will tighten the filter sufficiently.Every new oil filter has rotation index marks that are spaced at 90 degree increments. Use the rotation index marks as a guide for tightening the oil filter.
Illustration 3 g06022742
Remove the oil filler plug (3). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Capacities (Refill)". See Operation and Maintenance Manual, "Lubricant Viscosities". Clean the oil filler cap and install the oil filler cap.
Before you start the engine, check the oil level on oil level gauge (4). The oil level must be within the FULL RANGE on the oil level gauge.
Start the engine. Run the engine for 2 minutes. Inspect the machine for leaks. Stop the machine.
Wait for 10 minutes to allow the oil to drain back into the crankcase. Check the oil level. Maintain the oil level within the FULL RANGE on the oil level gauge.
Close the engine compartment.