CARTRIDGE GP-TURBOCHARGER 0R5491 - Caterpillar

Illustration 3 g02793465
(A) Front of the machine (B) Rear of the machineDiagonal Lashing
In areas where frictional lashing is not allowed, direct lashing can be used as shown below.
Illustration 4 g02795934
(A) Front of the machine (B) Rear of the machineTying Down the Machine
Tie Down Point - In order to tie down the machine, attach the tie-downs to the tie down points. The weight and the instructions that are given herein describe the machine as the machine is manufactured by Caterpillar.Refer to the Operation and Maintenance, "Specifications" for specific weight information.
Use proper rated cables and shackles for tying down the machine.
Use the rear eyes and the front eyes that are provided on the lower frame to fasten tie-downs. Use corner protectors for sharp corners.
Move the hydraulic lockout control to the LOCKED position.
If there is a requirement of diagonal lashing for tying down, use the proper tie-down point on the lower frame. Set the lashing angle which is on the longitudinal axis of the machine and the cable, at 30 to 50 degrees.Lifting the Machine Segments
Machine Without Components
Illustration 5 g01130787
Remove engine hood (1) .
Remove bracket (2) and fuel filter (3) . Lift eye (4) can now be accessed.
Illustration 6 g03368309
Fasten a proper rated wire cable to each lifting eye with a shackle. This machine has four lifting points on the front of the machine. The machine also has one lifting point on the rear of the machine.By using an appropriate lifting device, put tension on the lifting cables and slowly lift the machine.Counterweight
Illustration 7 g01416809
Refer to Operation and Maintenance Manual, "Counterweight Removal and Installation" for specific information.Stick with Bucket Cylinder
Illustration 8 g00581738
Use the two lifting eyes that are provided in the brackets on the top of the stick. Install shackles through the lifting eyes and fasten properly rated wire cable to the front section of the stick. Use a cloth in order to protect the lifting cable from being damaged by the edges of the stick.Slowly lift the stick with the bucket cylinder.Bucket
Illustration 9 g00115251
(1) Pin (2) Sleeve (3) Bolts (4) NutsInstall pin (1) and sleeve (2) in the brackets of the bucket. Illustration 9 indicates the method to secure pin (1) with bolts (3) and nuts (4) . Fasten two proper rated wire cables to pin (1) .Boom with Stick Cylinder
Illustration 10 g00581739
Use the two lifting eyes that are on top of the boom. Fasten two properly rated wire cables to the lifting eyes with shackles and secure the piston rod to the cylinder tube.Slowly lift the boom and the stick cylinder.Boom Cylinder
Illustration 11 g00581741
Fasten two properly rated wire cables to the boom cylinder and secure the piston rod to the cylinder tube.Slowly lift the boom cylinder.Walkway
Illustration 12 g00581742
Use two properly rated wire cables. Fasten the lifting cables to the positions that are indicated in Illustration 1.Lift the walkways one at a time.