CARTRIDGE GP -A 0R7242 - Caterpillar

(1) Torque for the nut on the pinion flange with 5P3413 Thread Sealant on the threads ... 475 47 N m (350 35 lb.ft.)(2) Torque for bolts ... 244 27 N m (180 20 lb.ft.)(3) Torque for nuts (11 each side) and bolts (nine each side) that hold the cover to the case ... 135 15 N m (100 11 lb.ft.) Apply 9S3263 Thread Lock on the threads of the studs (11 each side) then tighten the studs to a torque of ... 55 10 N m (41 7 lb.ft.)(4) Apply 9S3263 Thread Lock on the threads of the studs (six) then tighten studs to a torque of ... 30 5 N m (22 4 lb.ft.)(5) Rubber toric seals and all surfaces in contact with them must be clean and dry at assembly. Put a thin layer of oil on the surfaces of the metal seals that are in contact just before installation. Put lubricant on all other seals at assembly.(6) Apply 7M7260 Liquid Gasket Material between sprocket and lock.(7) Torque for nut on the sprocket shaft ... 334 33 N m (243 24 lb.ft.) To install lock cover, rotate nut clockwise only.(8) Distance between face of flange and shoulder of pinion ... 3.0 0.8 mm (.12 .03 in.) after flange and pinion have been pushed together with a force of ... 133 to 178 kN (15 to 20 ton)(9) Torque for bolts that hold the drum to the flange ... 120 to 135 N m (90 to 100 lb.ft.)(10) Apply 9S3263 Thread Lock on the threads of the studs (six) then tighten the studs to a torque of ... 30 5 N m (22 4 lb.ft.)(11) Torque for nuts that hold gear to shaft. Tighten nuts to 80 7 N m (60 5 lb.ft.). Then turn nuts 120° 5° more. Torque for nuts after turning ... 305 N m (230 lb.ft.).(12), (13) See FINAL DRIVE BEARING INSTALLATION.(14) Distance between face of sprocket and the end of the splines on the shaft ... 3.0 0.8 mm (.12 .03 in.) after sprocket has been pushed on the shaft with a force of ... 311 to 356 kN (35 to 40 ton)