CARTRIDGE GP-TURBOCHARGER 1280621 - Caterpillar

Illustration 1 g02042457
Schematic of the "Auxiliary Pedal 1 Control Pressure" Sensor
This diagnostic code is associated with the "Auxiliary Pedal 1 Control Pressure" Sensor. This diagnostic code is recorded when the Machine ECM reads the frequency of the signal and the frequency is not within an expected range. Note: Before performing the following procedure, ensure that the diagnostic code for this procedure is active.The possible causes of this diagnostic code are listed below:
The sensor has failed.
Intermittent connections or poor connections
The Machine ECM has failed. A failure of the ECM is unlikely.Test Step 1. CHECK THE +8 DCV SUPPLY VOLTAGE.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector from the sensor.
Turn the disconnect switch and the key start switch to the ON position.
At the machine harness connector for the sensor, measure the voltage (DCV) between contact 1 (wire J850-WH(White)) and contact 2 (wire 235-BK(Black)).
At the machine harness connector for the sensor, measure the voltage (DCV) between contact 1 (wire J850-WH(White)) and frame ground. Expected Result:The voltage is 8 0.5 DCV for both measurements. Results:
OK - The voltage is 8 0.5 DCV for both measurements. The voltage is correct. Proceed to Test Step 2.
NOT OK - The voltage is NOT 8 0.5 DCV for both measurements. The voltage is not correct. The Machine ECM has failed or the harness has failed. Repair: A failure of the ECM is unlikely. Verify the harness. If the harness is correct, replace the Machine ECM. STOPTest Step 2. VERIFY THE GROUND OF THE SENSOR.
At the machine harness connector of the sensor, place a jumper between contact 2 (wire 235-BK(Black)) and frame ground.
At the machine harness