CARTRIDGE-GREASE 1291938 - Caterpillar

Illustration 3 g01477138
The pressure tap group and the correlating test lines on the transmission.
(A) Oil pump output pressure tap
(E) Torque converter inlet pressure P3
(F) Speed clutch pressure tap P1
(J) Direction clutch pressure tap P2
(K) Transmission lubrication pressure tap
(28) Transmission control valve
Illustration 4 g01478090
Transmission control valve
(F) Speed clutch pressure tap P1
(J) Direction clutch pressure tap P2
(29) Plug for load piston
Install the correct hose assembly from 1U-5482 Pressure Adapter Group on the following pressure taps: (A), (F), and (J). Attach the opposite end of the hose assembly to the 0 to 3400 kPa (0 to 580 psi) pressure gauge in the 1U-5481 Pressure Gauge Group. See Illustration 2 and Illustration 3 for the location of pressure taps.
Engage the parking brake. Shift the STIC transmission direction control switch to the NEUTRAL position. Shift the transmission to first speed. Start the engine and operate the engine at low idle.
Depress the right service brake pedal and hold the right service brake pedal. Release the parking brake. Watch the pressure gauges. Shift the STIC transmission direction control switch from the NEUTRAL position to the FORWARD position. Increase the engine speed to high idle. Make sure that the transmission oil is at normal operating temperature. The needle on the pressure gauge for the Number 2 clutch should rise. The needle on the pressure gauge for the Number 5 clutch should rise. The pressure readings must be within the values that are found in Table 3.With the transmission in the FORWARD position, shift through the remaining forward speeds and return to the FIRST SPEED position. The pressure reading for each clutch that is energized must be within the values that are found in Table 3. This checks the pressure of all the speed clutches.
Perform Step 4 for all reverse speeds. The same pressure levels should be noted in all reverse speeds.Test for the Lubrication Oil Pressure
Use the following procedure to check the pressure of the transmission lubrication oil.
Install the correct hose assembly from 1U-5482 Pressure Adapter Group on pressure tap (K). Attach the opposite end of the hose assembly to the 0 to 400 kPa (0 to 58 psi) pressure gauge in the 1U-5481 Pressure Gauge Group.
Start the engine and operate the engine at high idle. Observe the pressure gauge. With the oil at normal operating temperature, the lubrication oil pressure must be within values that are found in Table 3.Transmission Pressures
Table 3
Transmission Pressure
Pressure Pressure Tap Position of Governor Control Lever Adjustment
Pressure at Low Idle Pressure at High Idle
Oil Pump (A) This pressure is identical to speed clutch pressure P1. This pressure is identical to speed clutch pressure P1. -
Speed Clutch P1 (Initial Pressure) (F) The pressure is 586 35 kPa (85 5 psi) when the direction switch is in the NEUTRAL position and plug (29) for the load piston is removed. - Add spacers (31) or remove spacers (31).
Speed Clutch P1 (F) This pressure must not be more than 350 kPa (50 psi) below the pressure at high