CARTRIDGE GP-VANE PUMP 1364815 - Caterpillar

Refer to the Owner's Manual of the OEM for your type of controls. Use the following procedure in order to start the engine.
Place the transmission in NEUTRAL. Disengage the flywheel clutch in order to allow the engine to start faster. This also reduces the draining of the battery.
Move the throttle to the low idle position.
Turn the ignition switch to the ON position. Note: If the indicator lamp for the Air Inlet Heater (if equipped) turns ON, wait until the lamp turns OFF before starting the engine. The Air Inlet Heater (if equipped) will become disabled if the engine is started with the lamp ON. A disabled Air Inlet Heater could result in emission of excessive white smoke after the engine has started.Note: The Air Inlet Heater (if equipped) may not have an indicator lamp. Wait for 30 seconds before you start the engine if the Air Inlet Heater (if equipped) does not have an indicator lamp. The operator will notice movement of the needle in the gauge for voltage. This movement is due to the cycling of the Air Inlet Heater (if equipped).
Push the start button or turn the ignition switch to the START position in order to crank the engine. If the engine fails to start within 30 seconds, release the start button, or the ignition switch. Wait for two minutes in order to allow the starting motor to cool before attempting to start the engine again.
As soon as the engine starts, release the start button, or the ignition switch.
Oil pressure should rise within 15 seconds after the engine starts. Do not increase engine rpm until the oil pressure gauge indicates normal. If oil pressure is not indicated on the gauge within 15 seconds, DO NOT operate the engine. STOP the engine, investigate and correct the cause.
Allow the engine to idle for approximately five minutes. Idle the engine until the water temperature gauge has begun to rise. Check all gauges during the warm-up period. Note: Oil pressures and fuel pressures should be in the normal range on the instrument panel, if equipped. Do not apply a load to the engine or increase engine rpm until the oil pressure gauge indicates at least normal pressure. Inspect the engine for leaks and/or unusual noises.