CARTRIDGE GP-TURBOCHARGER 1954442 - Caterpillar

Illustration 2 g01089425
Tooling (B) ( 6V-7830 Pressure Gauge (Tetragauge))
Table 1
Required Tools    
Tooling    Item    Part
Number    Description    Qty    
A     A1     8T-0855     Pressure Gauge
4000 kPa (580 psi)     1    
A2 6V-3989     Fitting     1    
A3 6V-4143     Coupler     2    
A4 177-7861     Hose As
41370 kPa (6000 psi)     1    
B     B1     8T-0862     Pressure Gauge
500 kPa (72 psi)     1    
B2 8T-0860     Pressure Gauge
40000 kPa (5800 psi)     1    
B3 8T-0855     Pressure Gauge
4000 kPa (580 psi)     1    
B4 6V-3081     Hose As
41500 kPa (6020 psi)     1    
B5 4S-6399     Connector     1    
B6 6V-4144     Coupler     1    Test Procedure
Move the machine to a smooth horizontal location.
Extend the counterweight fully. Engage the parking brake. Turn the engine OFF.
Illustration 3 g01283132
Place the counterweight lock lever in the LOCK position.
Illustration 4 g01286574
Place the counterweight control lock in the LOCK position.
Illustration 5 g01286581
The pressure tap for the priority valve is located behind the access door on the right fender of the machine.
Locate the remote pressure taps.
Illustration 6 g01286683
The power train oil filter is not pictured. (P2) Pressure Tap for the Priority Valve (M) Pressure Tap for the Torque Converter Inlet (N) Pressure Tap for the Torque Converter Outlet
Attach tooling (A or B) to pressure tap (P2) .The priority valve will regulate the oil at high pressure in the following conditions:
Engine speed is less than 1300 rpm and the parking brake is off. (The priority valve will remain at high pressure until the engine rpm reaches 1350 rpm.)
A transmission shift is in progress.
The power train oil temperature is less than 40 °C (104 °F). (The priority valve will remain at high pressure until the power train oil temperature reaches 45 °C (113 °F).)
A transmission clutch fill calibration is in progress.
Start the engine. Warm the power train oil to a temperature of 80° 10°C (176° 18°F).
Make sure that the transmission is in NEUTRAL.
Operate the engine at LOW IDLE (800 rpm).
Disengage the parking brake.
Check the pressure at tooling (A or B). The pressure at tooling (A or B) should be 2760 105 kPa (400 15 psi) (high pressure).Note: When the parking brake is engaged the pressure at tooling (A or B) will always be low pressure.ReferenceSee Specifications, Systems Operation/Testing and Adjusting, "Pressure Charts" in this module for additional pressure values.
If the pressure at tooling (A or B) is not within the specified limits, perform the following adjustment procedure.Adjustment Procedure
Illustration 7 g00618395
(3) Priority valve (4) Inlet relief valve (torque converter) (28) Adjustment screw for the torque converter inlet (29) Adjustment screw for the priority valve
Loosen the locknut that is on adjustment screw (29). Maintain the position of the adjustment screw.Note: One turn of the adjustment screw changes the pressure setting by 135 kPa (20 psi).
Turn adjustment screw (29) by the desired amount.
Do not allow the adjustment screw to rotate when the locknut is