CARTRIDGE GP-TURBOCHARGER 2678658 - Caterpillar

Warning Plates and Labels
There may be several specific safety signs on your engine. Their exact location and description of the hazard are reviewed in this section. Please take the time to familiarize yourself with these safety signs.Make sure that you can read all safety signs. Clean or replace these if you cannot read the words or see the pictures. When cleaning the labels use a cloth, water and soap. Do not use solvent gasoline, etc.You must replace a label if it is damaged, missing or cannot be read. If a label is on a part that is replaced, make sure a new label is installed on the replaced part. See your Caterpillar dealer for new labels.General
Do not wear loose clothing and jewelry whenever working around engines or machine.Stop engine before making adjustments or repairs to the engine or driven equipment unless specified otherwise.Attach a "DO NOT OPERATE" or similar warning tag on the start switch, or start button, before servicing the engine. These tags, Form SEHS7332, are available from your Caterpillar dealer.Caution should be used to avoid breathing dust that may be generated when handling components containing asbestos fibers. If this dust is inhaled, it can be hazardous to your health. Components in Caterpillar products that may contain asbestos fibers are brake pads, brake band and lining assemblies, clutch plates and some gaskets. The asbestos used in these components is usually bound in a resin or sealed in some way. Normal handling is not hazardous as long as airborne dust which contains asbestos is not generated.If dust which may contain asbestos is present, there are several common sense guidelines that should be followed.1. Never use compressed air for cleaning.2. Use vacuum or wet methods for cleanup.3. Use exhaust ventilation on permanent machining jobs.4. Wear an approved respirator if there is no other way to control the dust.5. Follow environmental rules and regulations for disposal of asbestos.6. Avoid areas where asbestos particles may be in the air.Be sure the remote starting system is inoperative on engine being serviced.Disconnect and tape the battery ground lead before working on an engine to prevent accidental starting.To prevent injury, install guards over all exposed drive shafts, pulleys or any application with exposed rotating parts.Relieve all pressure in air, oil, fuel or water systems before any lines, fittings or related items are disconnected or removed. Be alert for possible pressure when disconnecting any device from a system that utilizes pressure. Do not check for pressure leaks with your hand.Use caution when removing cover plates. Gradually loosen (do not remove) the last two bolts or nuts located at opposite ends of the cover or device. Pry cover loose to relieve any spring or other pressure, before removing the last bolts or nuts.Always use tools that are in good condition and be sure you understand how to use them before performing any service work. Remove all tools, electrical cords and any other loose items from the engine before starting.Wear a hard hat, face shield, clothing, shoes,