CARTRIDGE AS 3E6267 - Caterpillar

The interval for the maintenance of the tube type heat exchanger depends on the operating environment of the vessel and on the operating time. The sea water that is circulated through the heat exchanger and the amount of operating time of the vessel affects the following items:
Cleanliness of the tubes for the heat exchanger
Effectiveness of the heat exchanger systemOperating in water that contains silt, sediment, salt, algae, and so on, will adversely affect the heat exchanger system. In addition, intermittent use of the vessel will adversely affect the heat exchanger system.The following items indicate that the heat exchanger may require cleaning:
Increased coolant temperature
Engine overheating
Excessive pressure drop between the water inlet and the water outletAn operator that is familiar with the normal operating temperature of the coolant can determine when the coolant temperature is out of the normal range. Inspection and maintenance of the heat exchanger are required if the engine is overheating.Cleaning the Heat Exchanger
Drain the cooling system. Refer to this Operation and Maintenance Manual, "Coolant - Change" for the procedure.
After closing the sea cock, remove the sea water pump inlet connection to drain the sea water system.
Remove the heat exchanger. Refer toDisassembly and Assembly Manual, "Aftercooler - Remove" for the procedure.
Disassemble the heat exchanger. Refer to Disassembly and Assembly Manual, "Aftercooler - Disassemble" for the procedure.
Turn the heat exchanger cores upside-down in order to remove debris.
Do not use a high concentration of caustic cleaner to clean the core. A high concentration of caustic cleaner can attack the internal metals of the core and cause leakage. Only use the recommended concentration of cleaner.
Back flush the cores with cleaner. Caterpillar recommends the use of Hydrosolv liquid cleaner. Table 1 lists Hydrosolv liquid cleaners that are available from your Caterpillar dealer.
Table 1
Hydrosolv Liquid Cleaners(1)
Part Number Description Size
1U-5490 Hydrosolv 4165 19 L (5 US gallon)
174-6854 Hydrosolv 100 19 L (5 US gallon)
(1) Use a 2 to 5 percent concentration of the cleaner at temperatures up to 93°C (200°F). Refer to Application Guide, NEHS0526 or consult your Caterpillar dealer for more information.
Steam-clean the cores in order to remove any residue. Flush the tubes of the heat exchanger core. Remove any other trapped debris.
Wash the core with hot, soapy water. Rinse the core thoroughly with clean water.
Personal injury can result from air pressure.Personal injury can result without following proper procedure. When using pressure air, wear a protective face shield and protective clothing.Maximum air pressure at the nozzle must be less than 205 kPa (30 psi) for cleaning purposes.
Dry the core with compressed air. Direct the air in the reverse direction of the normal flow.
Inspect the core in order to ensure cleanliness. Pressure-test the core. Many shops that service radiators are equipped to perform pressure tests. If necessary, repair the core.
Assemble the heat exchanger. Refer toDisassembly and Assembly Manual, "Aftercooler - Assemble" for the procedure.
Install the heat exchanger. Refer to Disassembly and Assembly Manual, "Aftercooler - Install" for the procedure. For more information on cleaning the core, consult your Cat dealer.