CARTRIDGE KIT 4J1310 - Caterpillar

General Information
Illustration 1 g00767179
(1) Diagnostic service tool connector for the ET (2) Diagnostic service tool connector for starting and chargingThe service tool connector is located on the console to the right of the operator's seat.
Illustration 2 g00767184
(3) Transmission/Chassis ECMThe transmission/chassis ECM is located on the outside of the cab on the right side.The Electrical System Schematic, Parts Manual and Operation and Maintenance Manual for the machine that is being serviced should be used to locate electrical components and connectors.The following information is a guide to reading the tables on the back of the Electrical System Schematic.
The "Component Location" table uses white circles to mark the locations in the profile of the machine and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.
The "Harness Connector Location" table uses white circles to mark the locations in the general view and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.Connector Contact Numbers
Illustration 3 g00554751
Electronic Control Module (ECM)
Illustration 4 g00556522
Machine Harness Connectors J1 and J2 that mate to the ECM.