CARTRIDGE 5112245 - Caterpillar

Cat Cooling System Cleaner
A. Procedure for cleaning the entire cooling system
Clean the radiator fins.
Clean the radiator fins after every 400 hours (Under dusty conditions, fins cleaning frequency will have to be increased).
For cleaning, blow the pressurized air through radiator fins in the reverse direction of the flow of radiator fan. Do not spill water on radiator fins.
K clean is designed to remove the contaminants like scale, oil, grease, rust, loose material present in the engine cooling system.
Add K clean in the ratio of 375 ml for every 16 liters capacity of radiator and balance clean water (mineral or similar water) in the radiator.
Run the engine for minimum 20-30 minutes.
Allow the water to cool down and remove the drain plug to drain the drain plug completely.
Refill the drain plug with plain clean water and run the engine for another 15-20 minutes for flushing the system.
Allow the water to cool down and drain the drain plug completely.
Observe the drained water, if still contents rust, scale and dirt repeat the above procedure one more time.B. Procedure for adding the coolant
After cleaning the entire system with K cleaner, fill the cooling system with K Cool Super Plus.
Close all drain plugs before the cooling system is filled.
Do not fill the cooling system faster than 20 liters per minute to prevent air pockets from developing. Air pockets result in incomplete fill and could possibly cause damaging steam.
After filling the cooling system run the engine for several minutes with the radiator cap off. Next install the radiator cap and run the engine at low idle until the coolant becomes warm.
Inspect coolant level from top tank. If necessary, add coolant and install radiator cap. Examine all cooling system components for leaks. If none are found, the engine is ready for service.
Add coolant only when the cooling system is cold. The temperature difference between the coolant in the engine and the coolant being added must not exceed 50 °C.
Add coolant only when the cooling system is cold. The temperature difference between the coolant in the engine and the coolant being added must not exceed 50 °C.C. Adding Coolant after Every 250 Operating Hours.
Note: During the 250 Hours check if a coolant loss is noticed, add K cool Super Plus.
The engine specially formulated coolant “K Cool Super Plus” with demineralized water & Glycol. Use only “K Cool Super Plus”coolant and do not use ordinary water. The “K Cool Super Plus” is available only through KOEL'S authorized dealer in suitable packings.