CARTRIDGE 6E4269 - Caterpillar

Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine.
Refer to the Maintenance Section for the detailed procedures. Refer to the Maintenance Interval Schedule for a complete list of scheduled maintenance.Inspect the hydraulic system for leaks. Inspect the hydraulic cylinders and inspect the cylinder rods and seals for damage or for excessive wear. Inspect the linkage and the work tool for damage or for excessive wear. Inspect the linkage for any missing or deformed pins. Make any necessary repairs.Inspect the following additional components:
the hydraulic tank
the hoses
the tubes
the plugs
the connecting joints
the hydraulic fittingsCorrect any leaks in the hydraulic system.Inspect the final drives for leaks. Make any necessary repairs. Check the oil level if you see leakage.Inspect the tracks for deep cracks, or steel cords that are cut. Inspect the lights for broken bulbs and for broken lenses. Replace any broken components.Inspect the films in the machine. Make sure that the films are legible. Inspect the engine compartment for any trash buildup. Remove any trash buildup from the engine compartment.Inspect the cooling system for any leaks, for faulty hoses, and for any trash buildup. Correct any leaks, and remove any trash from the radiator.Inspect the fuel system for any leaks, or faulty hoses. Check the fuel level and refill the tank if necessary.Inspect all of the belts for the engine attachments. Replace any belts that are worn, frayed, or broken.Inspect the air filter housing for cracks, loose clamps, or broken tubing. Squeeze the outlet tube slightly into a container in order to purge the dirt from the outlet tube.Inspect the exhaust system for loose connections or loose clamps.Make sure that all covers and guards are securely attached. Inspect the covers and the guards for damage.Inspect the handholds. Clean the handholds. Make any necessary repairs.Inspect the polycarbonate shield (if equipped) for damage. Tighten any loose bolts on the ROPS and other guards, that might be attached to the ROPS. If repairs are needed, consult your Cat dealer. Inspect the operator station for trash buildup. Check for trash buildup under the floor mat. Keep these areas clean.Inspect the foot pedals for proper operation. Remove any dirt buildup in and around the foot pedals. Replace any missing hardware.Make sure that the Operation and Maintenance Manual is located in the operator station and in good condition.Inspect the operator station for the following conditions:
Broken lenses on the gauges
Broken indicator lights
Broken switches
Other broken componentsAdjust the rearview mirrors (if equipped) for the best operator vision. Check the mounting bolts for tightness and get broken mirrors replaced immediately.