CARTRIDGE A. 8S6060 - Caterpillar

21. Remove nuts (34). Remove shafts (35). 22. Remove four bearings (36) from the arm assembly. 23. Remove sleeves (38) and cable (37) from the arm assembly. 24. Remove gear assembly (39) and washer from the housing assembly. 25. Remove pin (40) from the gear assembly. Remove plate assembly (41). 26. Remove gear assembly (42) from the housing assembly. 27. Remove bolts and nuts (44). Remove bracket (43). 28. Remove housing assembly (45) and two blocks from the arm assembly. 29. Remove arm assembly (46) and two blocks from the adjuster group. 30. Remove spring (47). 31. Remove bolt and nut (49). Remove shock absorber (48).32. Remove the bearings from each end of the shock absorber. 33. Remove bolt (51) from the bottom of the plate. Remove housing assembly (50) from the plate. 34. Remove retainers (55). Remove roller assemblies (56). It is necessary to destroy retainers (55) to remove them. 35. Remove pad (57) from the housing assembly.36. Remove retainers (59). Remove rods (52), springs (53), latch assemblies (54) and lever (58). It is necessary to destroy retainers (59) to remove them.Assemble Seat
1. Install lever (3), latch assemblies (1), rods (2), and springs (4) on the housing. Install the retainers that hold the lever and latch assemblies to the housing. Use a piece of pipe with a 15.9 mm (.625 in.) inside diameter approximately 12.7 cm (5 in.) long to install the retainers. 2. Put 5H2471 General Purpose Adhesive on the housing assembly and install pad (5). 3. Put roller assemblies (7) in position on the housing assembly. Make sure the swaged side (raised metal) (8) of the roller is away from the lower housing assembly.4. Install the retainers (6) that hold the roller assemblies. Use a piece of pipe with a 15.9 mm (.625 in.) inside diameter approximately 12.7 cm (5 in.) long to install the retainers. 5. Put plate (9) in position on the housing assembly (10). Install the bolt that holds the housing assembly on the plate. Tighten the bolt to a torque of 70 7 N m (50 5 lb. ft.). 6. Install bearings (13) in each end of the shock absorber.7. Put shock absorber (11) in position in the housing assembly. Install bolt (12) and nut that hold it. 8. Install spring (14) in the housing assembly.9. Install blocks (16) on each side of the arm assembly as shown. 10. Install arm assembly (15) in the housing assembly. 11. Install blocks (18) on each side of the arm assembly as shown.12. Install upper housing assembly (17) on the arm assembly. 13. Install bracket (19) on