CASE & PARTS GP-PLANETARY 3965183 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 350-7768 Electric Hydraulic Pump Gp
(115v) 1
350-7769 Electric Hydraulic Pump Gp
(230v) 1
9U-6815 Puller Stud 1
9U-6810 Nut 1
380-5720 Receiving Sleeve 1
465-6061 Double Acting Cylinder 1
447-2755 Bushing 1
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Start By:
Remove the rear tire.
Illustration 1 g01659653
Remove clip (3) and position the hose assembly out of the way.
Disconnect grease hose (1) and remove blocks (2).
Illustration 2 g01659714
Remove cap (4).
Illustration 3 g01659793
Attach a suitable lifting device to link assembly (5). The weight of link assembly (5) is approximately 417 kg (919 lb).
Attach a suitable lifting device to Tooling (A). The weight of Tooling (A) is approximately 209 kg (460 lb).
Position Tooling (A) onto pin (6). Remove pin (6). The weight of pin (6) is approximately 77 kg (170 lb).
Repeat Steps 5 and 6 for the other pin.
Remove link assembly (5).
Repeat Steps 1 through 8 for the remaining links.
Illustration 4 g01659994
For each of the links, remove retaining rings (7) and remove bearing (8).Installation Procedure
Install suspension link (5) in the reverse order of removal.