CASE AS-TMSN 3T4575 - Caterpillar

Safety Messages
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your authorized dealer for replacement manuals. Proper care is your responsibility.
Operation
Clear all personnel from the machine and from the area.Clear all obstacles from the path of the machine. Beware of hazards (wires, ditches, etc).Be sure that all windows are clean.Secure the doors and the windows.If the machine is equipped with rear view mirrors, then adjust the mirrors according to the specifications of the Operation and Maintenance Manual.Make sure that the horn, the travel alarm (if equipped), and all other warning devices are working properly.Fasten the seat belt securely.Warm up the engine and the hydraulic oil before operating the machine.Only operate the machine while you are in a seat.The seat belt must be fastened while you operate the machine. Only operate the controls while the engine is running.While you operate the machine slowly in an open area, check for proper operation of all controls and all protective devices. Before you move the machine, ensure that no one will be endangered. The machine can tip when you cross ditches, ridges, or other unexpected obstructions.Do not allow riders on the machine unless the machine has the following equipment:
Extra seat
Extra seat belt
Roll over Protective Structure (ROPS)Note any needed repairs during machine operation. Report any needed repairs.Avoid any conditions that can lead to tipping the machine. The machine can tip when you work on hills, on banks and on slopes. Also, the machine can tip when you cross ditches, ridges, or other unexpected obstructions.Avoid operating the machine across the slope. When possible, operate the machine up the slopes and down the slopes.Maintain control of the machine.Do not overload the machine beyond the machine capacity.Be sure that the hitches and the towing devices are adequate.Never straddle a wire cable. Never allow other personnel to straddle a wire cable.Before you maneuver the machine, make sure that no personnel are between the machine and the trailing equipment.Always keep the Rollover Protective Structure (ROPS) installed during machine operation.Operation in a Blast Zone
Machines equipped with Object Detection should not operate within 30 m (98.43 ft) of a blast site. This blast site warning does not supersede the published requirements or regulations found in "Title 30 of the Code of Federal Regulations (CFR)". This warning does not allow deviation from the published requirements or regulations found in "Title 30 of the Code of Federal Regulations (CFR)". A hazard assessment should be conducted by each customer. Every customer should meet all the requirements of "Title 30 of the Code of Federal Regulations (CFR)" to ensure the safe storage, transportation, loading, and blasting of any explosive.