CASE-GEAR 4831210 - Caterpillar

(4)Drive Pinion, Blade Lift And Blade Lift Shaft And Link Ball Sockets
Lubricate 5 fittings on each side. Total 10 fittings.(5)Center Shift Pinion Drive Housing And Link Ball Sockets
Lubricate 3 fittings.(6)Circle, Shoes And Spacers
Apply lubricant with a paddle to top and bottom of circle, front and back of 4 guide shoes and ends of circle teeth.(7)Power Control Output Shaft
Lubricate 1 fitting.(8)Scarifier
1. Lubricate 1 drive housing fitting. 2. Lubricate 4 link ball sockets and 1 drive shaft fittings.(9)Steering Gear Shafts
1. Lubricate 3 fittings. 2. Lubricate 1 fitting (recessed in bolster housing).(10)Steering Cylinder, Draft Ball Joint And Tie Rod Block
Lubricate 8 fittings. (11)Tie Rod Ends, Front Wheel Rack And Worm Gear Housing
Lubricate 4 fittings.(12)Tie Rod And Steering Arm
Lubricate 3 fittings at each front wheel. Total 6 fittings.(13)Lean Pivot And Knuckle Pins
Lubricate knuckle pins top and bottom, at each front wheel. Total 4 fittings.(14)Wheel Rack And Axle Pivot Pin
Lubricate front wheel rack and axle pivot pin at front. Total 3 fittings.(15)Front Wheel Lean Pivot Pins
Lubricate 3 fittings at each front wheel. Total 6 fittings.(16)Bevel Pinion And Wheel Lean Housing And Shaft
Lubricate 5 fittings.(17)Wheel Lean And Scarifier Shafts Support Bearings
Lubricate 2 fittings.