CASE 6V9449 - Caterpillar

Illustration 1 g00517167
Illustration 2 g00517169
View A-ALeft side (1) Rubber toric rings and all contacting surfaces must be clean at assembly. Apply a thin film of oil to the surfaces that contact the metal seals prior to assembly. (2) Apply 9S-3263 Thread Lock to the threads of the 12 bolts. (3) 7I-5617 Shim Pack Shim Pack thickness ... 5.55 0.08 mm (0.219 0.003 inch)Note: See the Steering System Testing and Adjusting, "Front Wheel Bearing - Adjust" in order to determine the amount of shims to use. (4) Final torque for 14 bolts ... 530 70 N m (391 52 lb ft)Note: Perform the procedure in the Steering System Testing and Adjusting, "Front Wheel Bearing - Adjust" before you install these bolts. Apply 9S-3263 Thread Lock to the threads of the 14 bolts. Then, tighten the bolts to the specified torque. (5) Prior to assembly, make sure that the rim mounting surface is free of paint and free of grease. (6) Torque for studs ... 230 30 N m (170 22 lb ft)Note: Apply 7M-7456 Compound to the threads of the studs. (7) Torque for nuts ... 880 80 N m (649 59 lb ft) (8) This stud and this nut are only used for the left side assembly. The right side assembly has a hole here.