CASE-TRANSM. 9S8790 - Caterpillar

Assemble display electronic control group (6) to bracket assembly (5) using four bolts (7) and four washers (8). Refer to Illustration 14.
Illustration 15 g06280707
(9) 365-8373 Fastener
(10) 8T-0326 Bolt
(11) 8T-0328 Hard Washer
Install the front cab liner removed in Step 2 with seven fasteners (9). Cover the front sun visor removed in Step 2 with four screws.Install the display assembly assembled in Step 6 to the front headliner inside the cab with two bolts (10) and two washers (11) as shown in Illustration 15.Route the display cable and secure the extra length behind the bracket with strap.
Illustration 16 g06280708
(9) 365-8373 Fastener
Install the rear cab liner removed in Step 2 with two fasteners (9). Install the rear sun visor removed in Step 2 with four screws. Cover the right rear ROPS pillar wiring and the rear electrical cover removed in Step 2 inside the cab. Refer to Illustration 16.
Illustration 17 g06280709
(L) Panel
Open engine hood panel (L) as shown in Illustration 17.
Illustration 18 g06280710
(M) Panel
Remove the left side engine hood panel (M) as shown in Illustration 18.
Illustration 19 g06280711
(1) 333-8153 Connection Assembly
(3) 7K-1181 Cable Strap
(12) 268-8643 Cable As
Route a new cable assembly (12) from connection assembly (1) outside the cab along the machine chassis harness. Secure cable assembly (12) with cable straps (3). Refer to Illustration 19.Adjust length of cable to ensure that the door can be closed without straining the cable.
Illustration 20 g06280712
(13) 347-1668 Camera
(14) 258-7485 Bracket
Sub assemble camera (13) to mounting bracket (14) with two nuts provided in the camera group as shown in Illustration 20.
Illustration 21 g06280714
(13) 347-1668 Camera
(15) 8T-4189 Bolt
(16) 8T-4224 Hard Washer
Install the sub assembled camera (13) in Step 12 to the center of machine hood grill door with four bolts (15) and four hard washers (16). Refer to Illustration 21.
Illustration 22 g06280715
(N) Grommet
Feed the camera cable through the hood door panel and insert through the included grommet (N). Refer to Illustration 22.
Illustration 23 g06280716
(P) Grill group
(3) 7K-1181 Cable Strap
(12) 268-8643 Cable As
Open the machine hood grill group (P). Route cable assembly (12) further along the machine chassis harness and to the hood door pillar. Secure the cable assembly (12) with cable strap (3). Connect cable assembly (12) to the camera connector and adjust the cable length to ensure hood grill group (P) can be closed without straining the cable. Close the hood grill group after installation is completed. Refer to Illustration 23.
Illustration 24 g06280718
(Q) Screw
Install the left side panel removed in Step 1 with four screws (Q). Refer to Illustration 24.