CASING 2L7796 - Caterpillar

Tools Needed For Calibration Procedure
6V4141 Tool Group
Additional tools that are also needed, but not shown, are as follows. Adjustment Procedure
1 Install the pump housing in the 2P8315 Bracket Assembly (part of 6V3116 Adapter Group). Use the 8S2243 Wrench to remove the fuel pumps from the pump housing. Remove the air fuel ratio control, if so equipped, and the cover over the torque control group.2 Put pin (1) in hole (A). [For 4 or 6 cylinder pump housings, use 3P1545 Pin (17.3734 mm). For vee fuel systems, use 3P1546 Pin (15.9410 mm). The pin length is given on the large diameter of the pin.]3 Use a 1D4533 Bolt and a 1D4538 Bolt to fasten 5P6602 Adapter (2) in position. Put 8S7271 Screw (3) in adapter (2), and use the 6V6069 Torque Screwdriver with a 6V6076 Bit to tighten screw (3) to a torque of 2.3-2.8 N m (20-25 lb in).4 If the