CHAIN GP-ROLLER 5079307 - Caterpillar

Illustration 1 g00614165
Schematic of the Swing Pump Swashplate SolenoidThis diagnostic code is associated with the Swing Pump Swashplate Solenoid. The possible causes of this failure are listed below:
The solenoid energizer circuit is open.
The solenoid has failed.
The return circuit of the solenoid is open.
The machine ECM has failed. This is unlikely. When this failure occurs, a warning is displayed on the message center and the machine ECM disables the circuit. Note: The following test procedure may create other diagnostic codes. Ignore these created failures and clear these diagnostic codes when the original failure has been corrected.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. DO NOT start the engine.
Disconnect the suspect solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper between contact 1 (wire P959-GN) and contact 2 (wire H716-WH).
Observe the message center.Expected Result:The diagnostic code alternates between the active status and the inactive status as the jumper is installed and the jumper is removed. Results:
YES - The diagnostic code alternates between the active status and the inactive status as the jumper is installed and the jumper is removed. The machine ECM is operating correctly.Repair: The solenoid has failed. Replace the solenoid. Stop.
NO - The failure remains. The harness or the machine ECM have failed. Proceed to test step 2.Test Step 2. CHECK FOR OPEN HARNESS CIRCUIT
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect machine harness connectors J1 and J2 from the machine ECM.
The jumper that was placed between contact 1 (wire P959-GN) and contact 2 (wire H716-WH) in the previous test remains in place.
At the machine harness connector J2of the machine ECM, measure the resistance between contact J2-9 of the solenoid energizer circuit (wire P959-GN) and contact J2-18 (wire H716-WH). Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to test step 3.
NOT OK - The resistance is greater than 5.0 ohms. There is an open circuit in the machine harness.Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Clear all active failures from the message center by pressing the "OK" key.
Operate the machine.
Check the message center for an active diagnostic code. The diagnostic information may also be viewed with the ET. Expected Result:The diagnostic code for the solenoid is not present.Results:
YES - The diagnostic code CID 1150 FMI 05 for the solenoid is not present. The failure was probably caused by a poor electrical connection or an open at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation. Stop.
NO - The diagnostic code for the solenoid is present. The failure has not been corrected. The machine ECM has failed. It is unlikely that the ECM has