CHANNEL 0041567 - Caterpillar

Fire hazard
Electrical Shock - Hazard
Fire hazard General Information
Introduction
The 164-2691 Printer Group , when attached to the 140-2845 Crimputer , prints completed crimp measurement data such as:
crimp date,
hose type,
hose size,
and specific crimp information.The print also allows the operator to print original and adjusted database information.
Illustration 3 g02888061
164-2691 Printer Group The 164-2691 Printer Group consists of the following parts:
Table 1
164-2691 Printer Group    
Item     Part No.     Description    
(1)     -     Printer    
(2)     164-2693     Ribbon    
(3)     -     Paper (one roll of 3 inch wide paper)    
(4)     -     Power Supply (110 VAC, 60 Hz)    
(5)     NEHS0725     Using the 164-2691 Printer Group    
Illustration 4 g02888080
Illustration 5 g02888081
Serial Cable (6) and CE Power Cable (7)
Table 2
Other Accessories    
(6)     164-2692     Serial Cable, DB9 to DB25 (required to connect printer to Crimputer)    
(7)     164-2695     Power Supply (CE-compliant) (110/220 VAC 60/50 Hz) available as a replacement    Additional Contact Information
For additional product support questions concerning this tool, contact the Dealer Service Tools Hotline at:USA: 1-800-542-8665, Option 1International:: 1-309-578-7372Printing
Printing crimp measurement data is done from the menu screens on the Crimputer. Part of the crimping procedure gives the operator the option of printing. The Crimputer software allows the operator to print 0, 1, 2, or 3 copies.Printing the database of "DVDT" (Delta Vertical Die Travel) values can be done by selecting the "UTIL" menu and then selecting the "PRINT" option on the Crimputer display screen. Either the original database or the adjusted database can be selected. Only these values which have been adjusted will be printed from the adjusted database.For additional information on the items that can be printed, refer to Operation Manual, NEHS0754, "Setup and Operation of the 145-7042 and 146-5861 Crimputer Groups ".Printer Setup
Illustration 6 g02888108
Connect Serial Cable (6) and Power Cable (4) To Printer
Remove the cover from the bottom of the printer and set DIP switches 2 and 3 on the switch block labeled DSW1 to "ON". All other switches on both switch blocks should be set to "OFF". Replace the cover.
Set up the printer by connecting 164-2692 Serial Cable (6) to the DB25 port on the underside of the printer.
Illustration 7 g02888105
Connect Serial Cable To Crimputer At Location Shown By Arrow
Connect power supply cable (4) to the printer as shown in Figure 7.
Connect the other end of serial cable (6) to the DB9 serial port on Crimputer.
Install a roll of 3 inch wide paper (one roll supplied) and the 164-2693 Ribbon into the printer.Note: Replacement paper (3 inch wide) can be purchased at a local stationary store. Replacement 164-2693 Ribbons can be purchased through the Caterpillar parts system and are packaged in boxes of 12.