CHANNEL 1158045 - Caterpillar

Which Generate This Code:This code is recorded if the identity of the machine as set by the harness code does not agree with the identity of the machine that is set by the engine ECM. The data for the machine application is erratic, intermittent or incorrect.Note: Other related diagnostic codes may cause this diagnostic code. Check for other related diagnostic codes.The possible cause of this diagnostic code is listed:
An incorrect harness code plug was used.
The wrong engine software was installed.The results of this diagnostic code are listed:
The actions of the machine are similar to another machine.If the correct harness code plug and software are installed, check for the following codes:
CID 0590 for the engine electronic control module
If the machine is shut down with an active code, the code will remain active when the machine is restarted. Until the correct software or the code plug is installed, the code will remain active.System Response:A warning of level 3 is present on the machine. The machine should not be started. Correct the following conditions if the condition exists.
The engine software is not appropriate for the machine.
The machine configuration (as selected by the code plug) is not appropriate for the machine.Test Step 1. VERIFY THE HARDWARE AND THE SOFTWARE PART NUMBERS
Verify whether the following part number is correct:
Check the description of the software group in ET for both the engine and the machine ECM. The description should match the machine type.Expected Result:Consult the Business Unit that is producing the product for the correct configuration of the machine. Results:
OK - All part numbers are correct. Stop.
NOT OK - All of the part numbers are NOT correct.Repair: One of the following modules may have the wrong part number and/or the software is NOT correct: the engine ECM and the machine ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Flash Program". Stop.