CHANNEL 5P8434 - Caterpillar

This machine is equipped with a Caterpillar Product Link communication device. When electric detonators are used, this communication device should be deactivated within 12 m (40 ft) of a blast site for satellite-based systems and within 3 m (10 ft) of a blast site for cellular based systems, or within the distance mandated under applicable legal requirements. Failure to do so could cause interference with blasting operations and result in serious injury or death.In cases where the type of Product Link module cannot be identified, Caterpillar recommends that the device be disabled no less than 12 m (40 ft) from the blast perimeter.
Do Not Weld or Drill (4)If Equipped, this safety message is on the post for the ROPS (Rollover Protective Structure).
Illustration 6 g01212098
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult your Cat dealer to determine this structure's limitations without voiding its certification.
Jumper Cables (5)This message is located behind the steps near the auxiliary start receptacle and at the rear of the engine compartment.
Illustration 7 g01370909
Explosion Hazard! Improper jumper cable connections can cause an explosion resulting in serious injury or death. Batteries may be located in separate compartments. Refer to the Operation and Maintenance Manual for the correct jump starting procedure.
Crushing Hazard (6)This message is on each side of the articulation hitch.
Illustration 8 g01371644
Stay back a safe distance. No clearance for a person in this area when the machine turns. Severe injury or death from crushing could occur.
Crushing Hazard (7)This message is on each side of the articulation hitch.
Illustration 9 g01371647
Connect the steering frame lock between the front and the rear frames before lifting, transporting, or servicing the machine in the articulation area. Disconnect the steering frame lock and secure the steering frame lock before resuming operation. Severe injury or death could occur.
Hot Fluids (8)This message is on the side of the radiator.
Illustration 10 g01371640
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.
No Ether (9)This message is on the end of the air cleaner.
Illustration 11 g01372254
Do not use ether. This machine is equipped with glow plugs. Using ether can create explosions or fires that can cause personal injury or death. Read and follow the engine starting procedure in the Operation and Maintenance Manual.