CHART-COMMONALITY 0J0000 - Caterpillar

Introduction
Illustration 1 g03223097
The tandem oscillation stopper on early models is deforming the 321-1429 Plate . The 321-1429 Plate is located on the front outer region on the left and right sides of the rear case frame.Rework Procedure
Manufacture Two Support Brackets
Illustration 2 g03219599
Use a minimum of A50 Steel or equivalent 16 mm (0.63 inch) by 30 mm (1.18 inch) bar stock (A) 130 ° (B) 161.5 mm (6.36 inch) (C) 30 mm (1.18 inch) (D) 222.5 mm (8.76 inch) (E) 16 mm (0.63 inch) (F) 140 °Weld the New Support Brackets in Place
Note: During this rework, protect any hoses and lines. Also, repaint any affected areas related to this rework procedure.
Illustration 3 g03220518
The new support bracket will be placed near the existing bracket that is marked with an arrow.
Illustration 4 g03220038
Weld the new support bracket in place using an 8 mm (0.31 inch) weld all around. Weld the bracket at both ends. (A) 140 ° angle end of the new bracket. (B) Maintain 40 mm (1.57 inch) between the existing bracket and the new bracket. (C) 130 ° angle end of the new bracket.