CIRCLE & BEAM AS 2814298 - Caterpillar

Illustration 1 g01071078
(1) Tighten the plug to the following torque. ... 90 15 N m (66 11 lb ft) (2) Tighten the plug to the following torque. ... 90 15 N m (66 11 lb ft) (3) Tighten the plug to the following torque. ... 90 15 N m (66 11 lb ft)
Illustration 2 g01099652
(4) Tighten the two bolts to the following torque. ... 270 40 N m (200 30 lb ft) (5) At installation, apply 9S-3263 Thread Lock Compound . (6) Tighten the six bolts to the following torque. ... 270 40 N m (200 30 lb ft) (7) At installation, apply hydraulic oil to the rolling surfaces and sliding surfaces. (8) Coil assembly Voltage ... 24 VDC Maximum current at 100 °C (212 °F) ... 1.9 Ampere Resistance at 25 °C (77 °F) ... 5.0 0.3 Ohms Temperature range ... -40 to 100 °C (-40 to 212 °F)
Illustration 3 g01099653
(9) Tighten the four bolts to the following torque. ... 2.2 0.25 N m (19 2.2 lb in) (10) 110-3978 Wave Spring (11) Spacer If the gap is between 0.40 mm (0.0157 inch) and 0.58 mm (0.0228 inch), use the following spacer. The thickness of the two 158-7991 Spacers is equal to the following dimension. ... 1.42 mm (0.0559 inch) If the gap is between 0.59 mm (0.0232 inch) and 0.74 mm (0.0291 inch), use the following spacer. The thickness of the 156-1157 Spacer is equal to the following dimension. ... 1.27 mm (0.0500 inch) If the gap is between 0.75 mm (0.0295 inch) and 0.95 mm (0.0374 inch), use the following spacer. The thickness of the 142-0149 Spacer is equal to the following dimension. ... 1.07 mm (0.0421 inch) If the gap is between 0.96 mm (0.0378 inch) and 1.13 mm (0.0445 inch), use the following spacer. The thickness of the 156-1156 Spacer is equal to the following dimension. ... 0.89 mm (0.035 inch) If the gap is between 1.14 mm (0.0449 inch) and 1.32 mm (0.0520 inch), use the following spacer 158-7991 Spacer . The thickness of the 158-7991 Spacer is equal to the following dimension. ... 0.71 mm (0.0280 inch)Use the following procedure in order to determine the proper thickness of the spacer.
Illustration 4 g01099654
(X) Bolt holes that are used in order to check the gap. (Y) Feeler gauges
After assembling the shaft with the bearings and lip seals into the body, assemble both roller cradle bearings without the timing pins. Do not install O-ring seals and the 175-7887 Dowels between the body and the head.
Do not install the 110-3978 Wave Springs and the Spacer . Install 179-6521 Test Ring into the body. With the port plate in the position, lower the head onto the body. Ensure that the parts are seated. Ensure that the parts are in the proper position. Position the head with an equal space between the head and the body in all places.
By using feeler gauges, measure the gap at the