CIRCUIT BREAKER AS 4175184 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 9U-5339 Bearing Puller Adapter(1) 1
9U-5338 Bearing Puller Adapter(2) 1
4C-9634 Puller Stud 1
9U-6832 Nut 1
6V-3175 Double Acting Cylinder 1
3S-6224 Electric Hydraulic Pump (115 Volt)(3) 1
9U-5266 Receiving Sleeve 1
(1) Used for removing the bearing that is located on the boom side of the stick
(2) Used for removing the bearing that is located on the bucket side of the stick
(3) 8S-8033 Electric Hydraulic Pump (230 Volt) is available.Start By:
Remove the stick. Refer to Disassembly and Assembly, "Stick - Remove". Note: For the removal of the sleeve bearings from the stick at the pin joint for the bucket control linkage, refer to Disassembly and Assembly, "Bucket Linkage Bearings and Seals - Remove".
Illustration 1 g00592359
Remove lip type seal (1) from the bore for the boom to stick pin.
Illustration 2 g00592391
Use Tooling (A) to remove the sleeve bearing.
Repeat Steps 1 and 2 in order to remove the lip type seal and the sleeve bearing from the opposite side of the stick.
Illustration 3 g00604131
Remove lip type seal (2) from the bore for the stick to bucket pin.
Illustration 4 g00687381
Use Tooling (B) to remove the sleeve bearing.
Repeat Steps 4 and 5 in order to remove the lip type seal and the sleeve bearing from the opposite side of the stick.